Jump to content
SAU Community

Another Friday Night Cruise

SweeT

By SweeT,
in Events

 Share

Recommended Posts

SweeT Collaborator

SweeT

Posted
Posted (edited)

We are meeting at Galleria Shopping Center on Friday, the 18th of September 8pm, departing around 8:45pm. Galleria is located on the corner of Walter Rd West and Collier Rd

The map will be available from the meet point for a GOLD COIN donation. The money will be going towards the SilviaWA club display for Powercruise.

We place a strong emphasis on safe driving at all our cruises, so if you intend to come along please obey the road rules.

So cruise on down for a chat and also check out some hot modified cars.

Regards

Krystal

t8khme.jpg

Edited by SweeT
Link to comment
https://www.sau.com.au/forums/topic/284461-another-friday-night-cruise/
Share on other sites
  • 2 weeks later...
Angr33_Sparcorella Community Regular

Angr33_Sparcorella

Posted
Posted

haha i saw everyone drive past Tuart Hill maccas at about 9ish. Sounded so nice, i high beamed a couple of u but didnt know if u saw me or not lol. i was waiting to go on the antilag bubbles cruise but now i wish i went with u :blush:.

Saw NR 32 WA on Charles st ?? crossing to get fuel. Oh hai Nick >_< Havnt seen the dirty two in a while, looking good :D

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Butters
      R34 GTR Speedo Drive , sensor type ?

      By Butters · Posted

      Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • Duncan
      spot the stagea

      By Duncan · Posted

      roof rail delete used to be a thing, they were made locally for a while too
    • AnimalGarage
      spot the stagea

      By AnimalGarage · Posted

      I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • AnimalGarage
      Can you mount the ATTESA pump in other locations?

      By AnimalGarage · Posted

      According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • joshuaho96
      R34 25GT Engine Light 21

      By joshuaho96 · Posted

      It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...