Jump to content
SAU Community

Recommended Posts

well i went out to la la land last sat and the gearbox decided to get stuck in third gear. clutch still worked, but wouldnt budge out of gear.

just went to move the car and it came out of gear after a lovely little grinding sound.

it has happened before and i had to get the box taken out and a spring and pivot ball?? replaced.

i guess my question is... should i drive it now that it seems to go through all the gears again, or am i gonna need to get it replaced again?? last time it cost $900, most of that was labour for getting the box in out and in again.

very concerned!!

any help would be fantastic.

Edited by jase33
Link to comment
https://www.sau.com.au/forums/topic/287089-holy-bananas-random/
Share on other sites

If this ever happens you are best to stop the car, switch off the engine and then attempt to get it out of gear. You don't want to be grinding teeth while the parts are still moving. This can be either a selector or 3rd gear synchro hub problem. Either way, this usually requires a reco to fix...$900 including R&R is actually cheap and I suspect the gearbox would not have been reconditioned for that amount...just the worn part replaced and the box put back together. I'd drive until it happens again...if it becomes frequent enough to annoy you then get your gearbox pulled apart for a reco.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If there's enough meat in the housing where you want to put the M12 adapter, then do it, but be aware that if/when you f**k that up you'll probably be repairing it before doing anything else. I'd just drill it out and tap ina 1/4" thread. No need for rocket surgery when the next most obvious thing will do. You could throw a 1/4 x 1/8 bush in there and use the same fitting you intended to use.
    • Is the only issue that the oil catch can is getting filled on hard runs? I'd be thinking more about oil control issues rather then the head lifting, especially as you aren't seeing spiking in the coolant pressure.  Do you need restrictors in the head, or better drains from the head? Does the sump need venting to the catch can?
    • Tried to make 1/8npt threads into compressor house of the turbo for my EBC. Threads got fu#ked and ended up with and elongated hole, so I do have good amount and nice threads 90% of the hole but 10% I only had 1-2threads there and rest of it is flush on that side of the hole.. So my idea is to do M12 x 1.25 to AN4 with braided lines instead of 1/8npt to 4mm vacuum silicone hose.  and hopefully get a better thread. M12 is quite big and AN4 is a little bit bigger than 4mm (4.9mm inner diameter braided PTFE hose). but this should work. Thoughts? Otherwise I will weld and adapter onto the turbo.   
    • Looks great, I hope everything is working well after all that time!
×
×
  • Create New...