Jump to content
SAU Community

Recommended Posts

How many times did David spin today?

None. It makes a difference having 4WD and a longer wheel base. Plus the 205 GTI is renown for lift off oversteer which is unusual in a FWD car.

  • Replies 187
  • Created
  • Last Reply

Top Posters In This Topic

Best was only 1:27, didn't really get a chance to put out a decent lap on the new QFM A1RM pads i put in after lunch, the shitty QFM HPX pads gave me no confidence at all while braking, was so focused on braking with the HPX pads I wasn't able to use the cones at all. Though in the future I'll try and remember where the initial turn in cones were

None. It makes a difference having 4WD and a longer wheel base. Plus the 205 GTI is renown for lift off oversteer which is unusual in a FWD car.

does it get any of that inside rear wheel lifting on the bends or is stiffer suspension needed for that?

does it get any of that inside rear wheel lifting on the bends or is stiffer suspension needed for that?

I didn't manage to get it to cock its leg but I believe that can be done with the standard suspension. I'll ask on the Aussiefrogs forums. Probably turn 1 after the main straight or the last turn of the S before going onto the main straight are the only corners at Mallala where this would happen. Maybe I wasn't driving hard enough :thumbsup:

I hope your engine is ok Luke.

Ringlands were Craigs problem, severe detonation busted them real good. Any slight bit of curry and mass smoke. Poor bugger, heart goes out to ya Craig! Big thanks for letting me borrow the camera, I'll hook you up with it again soon :P

Yeah no stress mate - car's not too bad although haven't opened it up much, kept the boost below 0.5bar for the drive home. Started it this morning and didn't blow any smoke so not sure - will do a compression test soon and see what's up with it. Worst thing was got home around 3pm and the house had been broken into and around $10k worth of stuff stolen - bloody pricks. So wasn't really the best day I've ever had, was supposed to fly to Darwin this morning as well but don't have a suitcase anymore so that didn't happen!!! :thumbsup:

Yeah no stress mate - car's not too bad although haven't opened it up much, kept the boost below 0.5bar for the drive home. Started it this morning and didn't blow any smoke so not sure - will do a compression test soon and see what's up with it. Worst thing was got home around 3pm and the house had been broken into and around $10k worth of stuff stolen - bloody pricks. So wasn't really the best day I've ever had, was supposed to fly to Darwin this morning as well but don't have a suitcase anymore so that didn't happen!!! :thumbsup:

That's f**ked mate, sorry to hear. Terrible day for you indeed! :P

ill have you know Andrew that i got my little hairdressers car around in a best time of 1:32.2, so not to far off you! Pretty happy with it considering that was my first time on a track and the car is essentially stock. Ive got some video here so ill get Luke to do his thing and put it up asap.

Great day overall best fun I've had in awhile.

Ecstatic about pulling 1:25.9 in the GTS-T, hopefully with a break upgrade and a slight touch up tune for a bit more power we'll see some faster times out of the red beast :-) :P

actually, that was the lines the instructor was telling me to take, late apex's through the first two corners, and then a slight slide through the third to keep the revs up to get a little more out of it on to the straight. I was experimenting with different stuff all day, because it sounded a bit weird to me as well, but this was definitely the fastest way through there in my car. I noticed benji in the starlet was also on the same line, so obviously its the better way through there for smaller, less powerfull cars.

I was using bridgestone potenza adrenalin RE001 in 205/50/R15 on a 5.5" rim. They held up really well, i was out for nearly 15 laps before they started to get hot and slid around a bit. Heslo has the same sort of tyre on the front of his GTR, and i think (but dont quote me) he has The Toyo R888 semi slicks on the back. Jugz in the maroon r33 gtst had some sparkly new Kuhmo KU36's (i m pretty sure thats what they're called) and Benji in the starlet also has the adrenalins, which he pretty well destroyed by the end of the day. I think you'll find most of the people out there were on performance street tyres, with the exception of a handfull of the more track preped cars.

out of curiosity, can you guys list your starting and best timed laps here?

i had a beer with one of the instructors (Dean) last night and he said that the best feedback for the instructors is to see how much people improve over the day.

for example, my starting time with the V35 at the private trackday last month was 1'40.9 and i got a series of 1'34s (timed by Glenn and Jugz) with a best of 1'34.5 for the day.

Edited by V35-2005

My first lap was 1:25.10. Lap at the end of the day was 1:24.20

Was kinda disappointed with how I went, as I said on the day felt as if I did better on the untimed laps then when the pressure came I just lost it. No matter, always next time and I had an assload of fun anyways :)

my first timed lap was a 1:36, which was after only 3 laps of the track. Best time was a 1:32.2, with out the cones. The instructor (dave) estimated his time in my car to be a high 1:30, so i was pretty happy with my efforts.

Luke, you just weren't pushing hard enough, when you think about it, both me and jugz ran off the track at some stage, and thus found the limits, and then went on to improve our times. You cruised around quite happily and without an untidy moment all day. Id say there's definatley more pace in the car than what your getting at the moment, you just have to pluck up the courage to take that extra 50m under brakes or push that extra 10 km/h through the corners but it means you might end up in the dirt.

My first lap was 1:25.10. Lap at the end of the day was 1:24.20

Was kinda disappointed with how I went, as I said on the day felt as if I did better on the untimed laps then when the pressure came I just lost it. No matter, always next time and I had an assload of fun anyways :)

Hey Luke, what part of the track did you have trouble with and what do you think you were doing wrong at the time?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • ok so if i wanted to go 18's i would go for 8's  in front 30+ or 32+ off set at front and the back 9 would be ok? what offset should i aim for.. then can i do some  hunting for wheel rim choices..    If i get this - will this fit all around: Size: 18 x 8.5 +37 - n what tyres size tyre should i get for front n back?  
    • Absolute f*cking nightmare. I had to take breaks constantly, and I was always pissed off when I got home. The line split in Italy on day 2 (we drove from the Netherlands), lol. Driving any narrow European town was... well, sh*t.   Appreciate it man. Here, I'll just drop a favourite from the load I took on Saturday.   I'll update here when things happen with the car, the thing is, with stock power and almost everything chassis-wise taken care of, there really are no problems. 268,000kms now and counting.  
    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
×
×
  • Create New...