Jump to content
SAU Community

Recommended Posts

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

CONGRATS LEEWAH...... I GUESS ALL THATS LEFT IS TO JOIN THE RH9 CLUB.......I RECKON WITH WHAT YOU HAVE AT THE MOMENT......YOU SHOULD BE ABLE TO PULL INTO THE HIGH 9'S VERY SOON. GOOD LUCK BUDDY. SEE YOU AT THE TRACK.

NEED TO ASK YOU ABOUT THE OS GEAR SET YOU BOUGHT. WHICH SUPPLIER? CAN YOU EMAIL ME ON [email protected]. Need some nittos as well.

*looks at the order for an OS Gearbox sitting at a popular importer's office...* hmmm

looks like your gearbox and my bodykit are arriving on the same ship

Congrats dave....

Just out of curiosity do you know why you have the small dip half way up your power curve???

Doc.

Hey Sam, from what I understand which may be incorrect is that the dip (more like a plateau actually :D) is due to when the NOS is being injected. The huge increase of fuel being pumped in needs to be burnt and it takes that extra moment to burn it and then power keeps rising again.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I was 99% sure the standard one is long enough to get there, you might just have to change the throttle orientation. If not, I remember someone having used an r31 cable instead, but that is probably harder to find than r33 by now...
    • HELP   Hey all, Is there an accelerator cable from another Nissan that can be used on the R33 GTST RB25DET with a Greddy forward facing plenum?  Thanks in advance  Rob 
    • Or do we think it was installed to give 1 bar of boost max, all day, everyday?
    • So could it be assumed it has been installed intentionally with potentially a power FC boost controller kit? 
    • Had my rig on Matt's dyno at PITS the other day. After a few years between tunes I added a few sensors and swapped intercoolers. Result. 553hp at 26psi. Not bad for an FJ20 that was built in 2007. The problem.. It filled the overflow bottle on hard runs which leads me to believe the head gasket isn't sealing. I have a coolant pressure sensor which was reading cap pressure at 22psi and occasionally overrunning to 23/24 psi on deceleration after a pull. It was not spiking. It has arp2000 head studs and a cometic gasket. As its been 18 years in service, I pulled the engine out and head off. Everything looks good but we obviously have an issue. Where I'm at.. Years ago I had the same issue, I checked the stud tension and they were all over the place. Some at 60 to 70 and some up near 90. I nipped them all to 100ft lbs and this stopped the water push until now. I believe this compromised the gasket back then. What do I do? 2 options are..  1) I bought arp 625+s, which I could put in with a new gasket. Thinking Kameari this time, reassemble and try again. 2) strip the block, get fire rings machined in with copper gasket and try that. I do not want to push it more than 28 to 30psi. I think the turbo will be out by then anyway. (G30-770). My other concern is the long term ability of a copper head gasket. Are they streetable for years? I feel like a new gasket with the new studs will probably suffice, but I don't know. Any thoughts welcome and advice on copper gaskets and fire rings. Thanks!
×
×
  • Create New...