Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

Have you tried to clean/degrease those spots Abe? They might just be some muck stuck to you disks - not necessarily burn spots.

Not yet, saw them a few days ago, shall try cleaning them tomorrow on my day off.

where do people go for there oil cooler/relocator kits??

seen some on ebay, but iv learnt my lesson with that below par shit...

outlaws. use billet earls plates.

Edited by scandyflick

not sure about brand, bought it off a NSW SAU forum member a while ago, he used it for ~1000k's then took it off to sell his car. comes with a big core and heaps long braided hoses. $260?

Who was talking about couriers to courier an engine interstate on here the other day, and what were the conclusions? Need to get an RB26 to Melbourne .... company names, phone numbers and prices if anyone has them pls.

Who was talking about couriers to courier an engine interstate on here the other day, and what were the conclusions? Need to get an RB26 to Melbourne .... company names, phone numbers and prices if anyone has them pls.

That was Adrian

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Absolutely could be. I collected data logs from when the O2 sensor was still out and also after I had replaced it so will try to compare them. Pretty confident that the affect is lowered with the new sensor, will check logs at the same RPMs/conditions. 
    • Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
    • Yes, unfortunately that's the one. Signal was noisy to begin with; after driving once and looking back at the logs I saw pressure constantly swinging between 0-200psi, or staying at 0 randomly for a few seconds. There's a lot of good sensors that share the same look and feel, so don't presume they're all bad. I bought mine for 20$ off Amazon and I should have read the reviews prior, as it's clear they're junk.  I purchased a lowdollerr motorsports sensor. 
×
×
  • Create New...