Jump to content
SAU Community

Recommended Posts

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

Here is the GTR ready to run, in 'as raced' trim with the 18s on it :(

gtrwarpaint.jpg

All effort from here will be focussed in getting the 35 to run consistent 1:12s without ruining its daily driven nature (keep air con, interior etc) :P

Edited by Martin Donnon

what are you talking about Damo.....wanli = no performance and thats coming from personal experience.....it became very hazardous in the hills with a bucket load of understeer and oversteer....very unpredictable

what are you talking about Damo.....wanli = no performance and thats coming from personal experience.....it became very hazardous in the hills with a bucket load of understeer and oversteer....very unpredictable

thats why i avoid chinese made :P japanese or euro ftw

-D

dunno where i said that Wanli are good, they are a long lasting tyre for someone on a budget who can't afford to shove KU36's on every tyre change. Everyone knows they are shit in the hills, i had them and agree they are not great, but i doubt they are any worse than standard run-of-the-mill family car tyres.

Anyway, since we all agree that Wanli's are shit, lets appreciate the awesomeness of the Willall GTR.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The downside of this is when you try to track the car, as soon as you hit ABS you get introduced to a unbled system. I want to avoid this. I do not want to bleed/flush/jack up the car twice just to bleed the f**kin car.
    • But again, the engineers said your cast aluminium would be fine based on the load that would be stretching that section. Same load stretching the bolts in a flex (not the twist), with a much smaller cross sectional area than the original part you've broken. It's why you'd need to be using higher strength bolts, but that's just making up for the strength you lose with less area...
    • I am truly amazed someone on this planet was able to cycle the pump using a scan tool. I've always ghetto cycled them on Nissan 90s shit boxes by slamming the brakes and pulling the handbrake to agitate the rear wheels enough to cause a speed difference
    • I didn't actually try it at the time but a Launch X431 with the appropriate software licenses/upsell will have the ABS bleed function. The Consult II you can still find some old sets of equipment but they're really, really expensive:   
    • Well I'll start by saying I'm not an engineer. I am going to go with the KiwiCNC ones.  They are made of 7050 alloy have good fillets and radius.  The material alone is in the order of double the strength and fatigue resistance - Those bolts, once torqued correctly place most of the load at the flat face of the mating surface - the 'stretch' you're talking about through torqueing them up would be far more than the extra stretch 'load' placed on them from a steering input or bump. (in my opinion) so I doubt they would flinch.    - but again "not an engineer".      oh and I don't think stitch welding 7050 is a good idea, likely just weaken the material (from what I read)
×
×
  • Create New...