Jump to content
SAU Community

Recommended Posts

plugs are new (gaped 0.8), well im going to see if new coil packs will make a difference, car has been misfiring on full boost or about 3500 4000rpm

Edited by Flash89
  • 2 weeks later...

well new coilpacks fixed the misfiring prob. no difference with the cold start

yeah when i do the idle adjust. car is prob reving around 900rpm take the tps plug off the car raises idle tp about 1200-1300 when i screw in the idle screw the rpm dont change at all. even tho the screw is all the way in too.

in the oil thread everyone has pretty much agreed that 10w40 is good for rb25's

but a 5w40 would be better again being thinner when cold

pull the air regulator (under the throttle body) out and give it a clean, make sure it goes all the way closed too (there is an adjuster)

also pull the iac valve off (one with the idle screw on it, at the back of the plenum) and clean it

clean both of them with carby/throttle body cleaner

The spring in the AAC valve should move freely. Also check the voltage on the solenoid.

Not sure about the air regualtor, I have two of them and they both cause bad cold starts. I actually think the spring is stuffed as the small bi-metallic disc does not fully close. Anyone know if this disc is supposed to remain closed with no voltage?

This thread is great when diagosing similar problems. http://www.skylinesaustralia.com/forums/Fi...ob-t174735.html

when ur car starts in the cold what rpm does it sit at and when it is hot what rpm does it sit at when start

it is easer to start when hot

what volts do u get with everything off and what it the voltage drop when u try to start and what type of battery do u have and how old is it

lets try to get this fixed.

i used to have the same problem.

Try adjusting the mixture screw... i think thats what its called. Its the screw on the manifold, on the same unit as the aac valve but on the other side. Wind that out a few turns, then start her up. If you still have trouble, get the car to temp and check your timing. I did this and new plugs and it fixed her right up.

However, it took a few goes to get it right with that screw, it progressively got better and better as i screwed out so i just did it one turn at a time. 2.5 turns got her perfect for me.

Mine was fully screwed in at first and therefore letting no air in and flooding i think... sounds like the same for you.

  • 2 weeks later...

i think you are talking about the idle screw. and yes i do disconnect the tps when i try adjust the idle still, the rpm stays the same.

yes it fires up straight away onces its warm.

battery is like 3months old and its massive, 4x4 battery. dont ask why i just replaced the same battery that was in there before

what i would also like to do, what is the difference with cold and warm starts, like with cold starts does it give less air cause its cold which means the air would be denser??

well i think we should rule out the battery ?

do u have a multimeter?

and or a

battery tester?

if battery tester test battery to see if u have enough CCA's

if multimeter then its a bit tricky. ideally you would use the battery tester but if thats not an option then make sure the battery is fully charged. attach multimeter u should read about 12.7V and wile reading the multimeter try and start the car if voltage drops bellow 10V it might be a good idea to take it to ur local auto 1 to have it tested there.

if the battery looks angry then replace and also check your alternator. all this is. is a multimeter attached to the car with it running and you should see between what 13.5V and 14.5V then turn on head lights. the voltage should drop for a second then come back up. also check for current draw. this is the multimeter attached in series to the battery with every thing hooked up but off, set multimeter to amp's setting.

next is your air filter clean? if not clean it

have u recently cleaned your AFM if not clean it.

oil change try something with a lighter weight at cold temp

setting the A/C to "cold" will help even if u leave the A/C off because this will make your coolant bypass the heater = faster warm up

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...