Jump to content
SAU Community

Recommended Posts

Hey guys.

Just wanting to get a few opinions on a few things.

I own a r33 Series 2 Gts-t Skyline.

i have no problem with over heating when on the move because getting good air circulation.

the problem is when iam just putting around town or in traffic..

Now it only seems to get xtreamly hot when putting around town with the ac on, the ac evaporator sits between the thermal fan and the radiator. On the highway the temp is fine and the ac works great.

With the ac off it works even better.. and getting around town with the windows down and no ac is just silly.

Would putting in a second thermal fan make much difference or do i just need a better coolent ?

Link to comment
https://www.sau.com.au/forums/topic/302777-overheating/
Share on other sites

What have u checked, have u done any work on car recently

Would putting in a second thermal fan make much difference or do i just need a better coolent ? band aid

Does ur thermo fan even kick in, if so id try coolant flush

How long ago was the water pump done, impeller could rusted away

Edited by Dorifta
Link to comment
https://www.sau.com.au/forums/topic/302777-overheating/#findComment-5019716
Share on other sites

I cant quite tell from your description, but do you have the factory clutch fan still on the car? Or an aftermarket electric one?

If you have an electric one, throw it away, and put the standard one back in place with the shroud.

Its really hard to make electric ones work properly, there are many threads around with issues regarding thermo setups. Most of them go back to stock because its not worth the hassle.

Link to comment
https://www.sau.com.au/forums/topic/302777-overheating/#findComment-5020103
Share on other sites

i'd also check the thermostat. i've had similar issues in the past and found it to be the thermostat (but have also had another issue caused by a dodgy fan). the fact that it runs fine when going faster indicates 2 things to me, 1: the fan is dodgy, or 2: the thermostat is dodgy and restricting flow and the fan alone simply can't pump enough air to overcome the heat soak in the engine bay and also can't get enough air through the radiator to get all of the extra heat out of the radiator.

the best way to tell if the thermostat is the issue is by how long the car takes to warm up. with a working thermostat the car should be up to temp within about 5 mins of driving (not just sitting there letting it idle for 5 mins). if the car takes much longer than that, or the needle doesn't make it to the halfway mark, or sits lower than halfway when on the highway with the aircon off then the thermostat is the issue as it isn't opening when it should and isn't closing when it should.

Link to comment
https://www.sau.com.au/forums/topic/302777-overheating/#findComment-5020950
Share on other sites

overheating at low speeds is usally caused by four things

Fans (bad clutch on mechanicals, lots with thermos. don't forget the shroud, its ugly but important

water pump loosing preasure

blocked radiator, you can try a flush in a bottle, they work soso, but a pro like natrad is better ( also bent fins on the core, they slow the air flow)

finally the old thermostat, they are usually cheep so just change em

if your motor has done a head gasket or similar in the past the water galleries in the block and such could also be a bit blocked, a flush take care of em

cheers

Link to comment
https://www.sau.com.au/forums/topic/302777-overheating/#findComment-5024257
Share on other sites

another way to check thermostat is take it out and put it in boiling water and see if it opens

it doesn't always show the problem vey well though. i've done the boiling water test before and it seemed fine, but once i put in the new thermostat it solved the issue

If temp goes north sitting in traffic & at the lights, the fan clutch is suss; likewise, the temp goes down when you're on the move.

it depends on how low the temp goes. if the temp only goes to normal when driving faster then it's likely to be the fan. the 2 cars i've had with thermostat issues would get hot when sitting in traffic, but when on the highway would drop down to about 1/4 temp

Link to comment
https://www.sau.com.au/forums/topic/302777-overheating/#findComment-5024362
Share on other sites

it doesn't always show the problem vey well though. i've done the boiling water test before and it seemed fine, but once i put in the new thermostat it solved the issue

it depends on how low the temp goes. if the temp only goes to normal when driving faster then it's likely to be the fan. the 2 cars i've had with thermostat issues would get hot when sitting in traffic, but when on the highway would drop down to about 1/4 temp

thanks guys might have to apply a few of these to my tow car which is starting to get hot very quickly when I'm not towing anything.

Link to comment
https://www.sau.com.au/forums/topic/302777-overheating/#findComment-5024482
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...