Jump to content
SAU Community

Recommended Posts

Do anybody's S2 + and - lights illuminate at night? I replaced the two globes on the driver's side of the gearstick and now my gear indicators sort-of light up, but the + and - buttons stay dark... which seems wrong.
With the lights, only two globes on the drivers side with a diffuser that goes around

all the gear selections including the + & -, however even with two new bulbs in

the + & - still dont light up.

Need brighter bulbs or retro fit a bulb/led on the left somewhere and they should light up fine.

2x 5w bulbs as said by 666DAN :banana:

  • 1 year later...

Okay, so I pulled the shifter apart today and found out it is actually relatively simple to get to the two bulbs underneath. First you need to take out the surrounding part of the console by removing the screw behind the ashtray and then prying it up with a blunt, flat object. Next you will need to use a philips head screwdriver to remove the two screws holding in the shifter itself. After this it is just a simple matter of prying off the plastic that surrounds the remains of the shifter (small white stick looking thing). Once this is done there are two small (tiny) globes directly below the "PRND32" section that can be removed/replaced. I will upload pictures tomorrow once I have the replacement bulbs!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...