Jump to content
SAU Community

Recommended Posts

Apparently a blue skyline (dunno what model) was crashed into a house this morning when the car was pulled up for a routine traffic check and the driver took off. Anyone know anything about this? God I hope it was stolen in the first place (would hate to think anyone on here is that fking stupid) and I HOPE it wasn't JD's...though I dare say we'd already know more if it was

Nah, twas not I.

But even the mother-in-law had to ring this morning to make sure. I told her I had to speak softly because I was under the bed, and I thought the police were at the door. Had her going for a good 5 minutes.

Crash actually happened in Ellerston Ave, so more Isabella Plains than Calwell.

*It's Melly*

Just saw it on the news, was making dinner heard skyline ran around the corner (bad idea in socks on lino) and saw it, they didn't show the colour or car which is unfortunate because that we would have at least know what model and what sort of blue.

I only heard a little bit of this and THOUGHT that I heard that it was a stolen dark blue 4 door R34 from a lady in Chisholm... But again, I only heard just a little bit of it so it could have been two stories in one by the time I paid attention.

I heard this article too and straight after there was a lady in that area that had her pulsar stolen so it may have been 2 in one.

Probably was just two seperate incidents then. Ignore me :no:

Lol, FoX, unfortunately??

Nah, twas not I.

But even the mother-in-law had to ring this morning to make sure. I told her I had to speak softly because I was under the bed, and I thought the police were at the door. Had her going for a good 5 minutes.

Crash actually happened in Ellerston Ave, so more Isabella Plains than Calwell.

Thats gold :no:

Sounds like a P-plater or stolen car to me. But I am biased against p-platers and car thieves in general...

Thats gold :P

Sounds like a P-plater or stolen car to me. But I am biased against p-platers and car thieves in general...

Understandable, but we aren't all bad. I've never done damage to another persons car but I've had damage done to mine on 3 separate occasions. But those P platers are bastards. :(

Thats gold :D

Sounds like a P-plater or stolen car to me. But I am biased against p-platers and car thieves in general...

Understandable, but we aren't all bad. I've never done damage to another persons car but I've had damage done to mine on 3 separate occasions. But those P platers are bastards. :O

So which one are you? The car thief or the P plater ;):):P

Understandable, but we aren't all bad. I've never done damage to another persons car but I've had damage done to mine on 3 separate occasions. But those P platers are bastards. ;)

So which one are you? The car thief or the P plater :P:P:P

holy crap! its Michele!!! :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...