Jump to content
SAU Community

Recommended Posts

R32 Skyline Club are having their Third cruise!

This will be a Morning Run, The destination will be Pinjarra Bakery, for those who have not been they make unreal pies & sausage rolls! They shut at 2pm hense the early start. The Cruise will not be a hwy run, its more of a forrest drive eventually getting to Pinjarra.

Place: Midland Central - Clayton Street, Midland. Out the front of JB Hi Fi.

Time: Sunday 28th March 2010 - Meet at 8:30am for 9am leave

Bring a tank of fuel, I cant stress this enough, we will go past a couple of fuel stops but we are not stopping at any.

The Cruise is intended for owners of R32 Skylines,

however I am not going to tell you to leave if you bring a different model of Skyline, but Skylines only please.

Dont expect to come to a race, the club prides itself with just enjoying coming out and just being able to drive.

See you there!

Link to comment
https://www.sau.com.au/forums/topic/311792-28th-march-r32-skyline-club-cruise/
Share on other sites

i should be able to make this as long its a skyline run my 32 is back on the road after my last cruzz and a meeting with a commodore up my ass but sound good and the bakery is GOOD

That's my birthday :down:

Though I do drive a R33 GTR, I did notice you won't tell me to leave, but I'd feel stink if I was the only tool in a 33 at a 32 club cruise

It's alright dude, I'll be there in my StagBus as the 32 is still without an engine :huh:

hey buba come with us bro if u want its up to you

and i just got that 30 blok yeah :blink:

Naice!

I'm hoping to have the CB installed in teh StagBus by the weekend (programming cable just rocked up :P) and *hopefully* some new front brakes! so I'll be keen to give them a workout ;)

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...