Jump to content
SAU Community

Recommended Posts

the reason u have no interest on these wheels is cause they are not REAL champ...

They are copies and only worth about $600-$750 for the set of 4.

But good luck with selling fake wheels mate

Link to comment
https://www.sau.com.au/forums/topic/312718-volk-te37/#findComment-5167572
Share on other sites

if you read the add they have just been powder coated..the reason they have no stickers..

i bought these in japan last trip with all the stickers..you dont buy china junk in japan...

champ

the reason u have no interest on these wheels is cause they are not REAL champ...

They are copies and only worth about $600-$750 for the set of 4.

But good luck with selling fake wheels mate

Link to comment
https://www.sau.com.au/forums/topic/312718-volk-te37/#findComment-5167591
Share on other sites

they are fake not real people

i have owned 2 sets of TE37 and on the wheels they say

RAYS ENG

VOLK RACING

MADE IN JAPAN

FORGED MONOBLOCK

JJ

These wheels dont have that stamped on the wheels

they are fake

Link to comment
https://www.sau.com.au/forums/topic/312718-volk-te37/#findComment-5168081
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...