Jump to content
SAU Community

Recommended Posts

Hey,

I have a USED but VGC set (6) Arias Standard Bore Forged Pistons, Rb25det conrods with ARP rod bolts. 5000km old before H/G went.

I have had these checked by an engine builder and they are in VGC!!!

For asking price i will throw in a RB25det Block, Crank, Girdle all to make a complete bottom end. Perfect for someone with a ported head or throw a headgasket and ARP head studs and you have a tough boost happy motor!!

Located Sunshine Coast

$1200 ONO but open to reasonable offers! Cash only no trades as ive had to pay for new setup!

Can post the pistons and rods at buyer expense but wont send a block due to weight.

Pm me or post on topic

PICS ON REQUEST!!

Link to comment
https://www.sau.com.au/forums/topic/316936-arias-forged-rb25det-pistons/
Share on other sites

  • 4 weeks later...
lolz no no was merely clarifying what was included cuz u said in previous posts u have had to sell the lot.... That is all :blink:

oh sorry my mistake, yea no longer have a block to sell with it so just selling pistons, rods and rod bolts.

ta

here's some pics of the pistons,

i haven't had a chance to get them cleaned as i was going to get this done when i got new rings and big ends for them.

if you need anymore pics let me know.

ta,

kails

post-55765-1275876003_thumb.jpg post-55765-1275876068_thumb.jpg post-55765-1275876103_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
    • Shock tower brace is in +5Kw....LOL  
×
×
  • Create New...