Jump to content
SAU Community

Recommended Posts

if you want it for better fuel usage by adding it be careful it melts rubber i used to make rubber rollers and conveyer belts and used it to help bond rubber to make it sticky before using glue.I have read the email about using small amounts for better mileage and combustion.i know they only say use small amounts for a full tank but be careful

Link to comment
https://www.sau.com.au/forums/topic/320235-tolunene/#findComment-5227526
Share on other sites

if you want it for better fuel usage by adding it be careful it melts rubber i used to make rubber rollers and conveyer belts and used it to help bond rubber to make it sticky before using glue.I have read the email about using small amounts for better mileage and combustion.i know they only say use small amounts for a full tank but be careful

Off topic, but did you ever do any work for Dexion?

Link to comment
https://www.sau.com.au/forums/topic/320235-tolunene/#findComment-5227626
Share on other sites

I too want to know where you can get tolunene from. But not because I suspect I've stumbled upon a miracle way to increase fuel economy that car manufacturers with their multi-million dollar R&D departments have yet to discover, it's because I'd like to take out the cat that keeps leaving footprints on my car.

Link to comment
https://www.sau.com.au/forums/topic/320235-tolunene/#findComment-5228456
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • ECUtalk pages don't mention they support the ABS computer (consult port has more than one CAN), so you might just need a different scan tool. But, I would expect ABS is a different light to the brake warning/handbrake light, do you see an ABS light come on for a few seconds when you turn the key from ACC to IGN? But since you said: I'd have a look at the ABS sensors in the rear hubs to make sure they are not damaged, disconnected etc.
    • OK, if it idles at 1000+ with the AAC, its not an idle airflow problem. The cold start valve just gives extra air when the engine is cold, but you have enough air without it to idle at 1000. I think you are back to a fuel problem, sorry. Can you see the fuel pressure staying constant or does it drop as the revs drop to a stall?  
    • Well, I was using ECUTalk software if that helps? Not sure if that only can see engine codes? Is there any other software I could give a try? Or any way I can get a blink code?
    • I never touched it, it should have. I'll try to give it an adjust. With IACV plugged in, it idles at around 1120RPM on average. Max 1200 RPM, Minimum 1025RPM before it starts dropping right before stalling. Took the data from the Nistune logs.
    • Thats what im trying to solve bro  no one with aem tuner experience would advice  much appreciate 
×
×
  • Create New...