Jump to content
SAU Community

Recommended Posts

Hi hows it going,

I currently have a Nissan Skyline r33 Series 2 gts-t, its got a few issues with it currently, it currently has a Front Mount Inter cooler, used to have a HKS Blow Off Valve but replaced it with the stock one. It has a 3" Full Exhaust, as well it has a Automatic boost controller however its got the display sort of smashed, so going to replace it soon with a manual one it as well has a turbo timer.

One of the issues is that its blowing black smoke and there and its leaking the black stuff from the exhaust onto the floor, also there is sense of a strong smell of petrol. My assumption its running quite rich, so im guessing could it be due for a tune, or it might be running too much boost but ive reved it ideling and it has been showing the 7 pound of boost. The car is currently unregestired however its never been driven, so dont if reving the car shows its real boost.

My 2nd question is, the oil is pretty much black, so would that mean its time for a oil change and oil filter change.

My 3rd question, is when sometimes its ideling it turns it self off so i was wondering could this be miss fires, or is it just due for a tune. Because im thinking maybe i need to replace the spark plugs. Also when its been slightly reved on a warm engine, sometimes it will shut off and wont turn back on until you give it about 5mins and it will start right back up. If i start it up straight after it will struggle to start up sort of like an old car.

If you could help me, it will be greatly appreciated.

Yours Truly,

Moz09

Link to comment
https://www.sau.com.au/forums/topic/321318-r33-skyline-problem/
Share on other sites

Get the O2 sensor checked, most common cause of running rich.

Oil shouldn't be black, so definitely change that. I would personally change it anyway as you don't know what the previous owner had been using.

When you returned the bov to stock, did you plumb it back properly or is it venting to atmosphere? If it is venting to the atmosphere then that could also be the cause of the car running rich

sounds like you have a mild vacuum leak sumwhere, check all vacuum lines, intercooler pipes etc

if that fails, check your air flow meter (borrow sum1 elses and fit it to see if it still runs the same)

if that fails, post here again and ill keep thinking, theres lots of things i can list but some more obvious/easy things to elimate first before the not-so easy stuff has to be checked, like injectors etc

Sounds like a combination of running rich and a vacuum leak as snozzle said (I'd be trusting his opinion on this, he's a champ :devil: ) I'm wondering, when your car "dies/turns itself off" does it hunt for a bit before it does? By that, I mean do the revs at idle just start going out of whack and then stall? If so then I'd definitely say vacuum leak somewhere. If this is the case, you can use something like carby cleaner and spray it around the intake manifold and pipes beforehand, you'll hear if it is

  • 2 weeks later...

Alright guys this is Moz09 however i have left the settings on my other computer which is out of use for now so using a mates account temporarily.

Anyways i found the vacuum issue as it was down to my boost controller vacuum line as it wasn't the right size one and was leaking, so ive replaced that now.

So this issue has been fixed, Ive as well done an oil and oil filter change.

However i still have stall's when its idling and its running rich still and still has backfiring issues when running idle, like you can actually feel the backfiring when your sitting inside.

Although I have thought about getting new spark plugs, but i don't want to chuck away money just yet, because i might not sure if new spark plugs will cause these stalls.

I haven't replaced the automatic boost controller yet, as i think it could be down to the automatic boost controller as sometimes the car wont rev past 2.5k and my mate told me its called a leap mode, so im going to replace it this week with a manual one and see if it fixes it.

However im still not 100% sure if it will fix the stalls, i am more interested in fixing the stalls currently rather then the car running rich and backfiring, however if you have any suggestions what could be the cause of the back firing and stalls as well it running rich.

Im guessing maybe the running rich issue is down to the ecu as i know the stock one does run rich but would the backfiring be the cause as well or?

I also have one more problem, sometimes when you actually let it warm up to like an operating temperature and you give it gas to about 4k, it will sometimes just shut off immediate would this be a cause of a another vacuum leak or misfire?

Hey hows it going, i switched today to the manaul boost controoler, im going to go tomorrow to buy some copper ones, however i eliminated the black exahust smoke problem as it was running quite a bit high boost before.

However i still tend to get a bit of a struggle around the 2.5k-3k mark when it comes to reving it as it will strugle to go past that so im guessing some sort of vaccum problem, however i looked at all the cables and intercooler piping and cant really find a leak.

Does anyone have any suggestions were i should look else?

I read somewhere about a small vacuum / airhose that used to go air box that if blocked, caused the car to to have a flatspot at the above rpm.

Try find a blocked hose or if someone else can elaborate cause its been 5+ months since i saw the thread with this info.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nope.    Grab a varex and turn it down as you get close to home, win win? 
    • So, I've had my V36 for about a month now and have already copped an "excessive exhaust noise" notification from QLD TMR, reported by someone in my local area. It's a twin as per the original, and can have a bit of a throaty note to it when idling cold 😄 and if I do get up it a bit, it can be noisy, but it did pass a roadworthy inspection before sale, so.... ... but in the interest of being a good neighbour, I do want to quieten it down a bit. Is anyone here running a quiet aftermarket cat-back on their V36 or 370Z? And the big, bold question: does an aftermarket cat-back really make much of a performance difference on these cars?
    • The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
×
×
  • Create New...