Jump to content
SAU Community

Recommended Posts

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

VICRoads VSI Number 10...

17.16 Rear Reflectors

Reference ADR 13.6.14 ADR 47/...

1. Purpose

Rear reflectors are intended to indicate the presence of a vehicle by the reflection of light from a light source not connected with the vehicle, the observer being situated near that source; Reflective number plates are not considered as reflex reflectors.

2. Presence

Mandatory

Two or more matching red reflectors complying with ADR 47/... shall be fitted to the rear of all vehicles.

3. Position

Pairs of reflectors facing rearwards shall be fitted symmetrically (same position on both halves of vehicle).

3.1 Width:

See Figure 7.16.1 below.

3.2 Height:

See Figure 7.16.1 below.

http://www.vicroads.vic.gov.au/vrne/vrnint...dElemFormat=gif

3.3 Length:

Rear reflectors shall be fitted to the rear and face rearward.

3.4 Geometric Requirements

The required angular range of reflected light is as shown in Figure 7.16.2 and 7.16.3.

http://www.vicroads.vic.gov.au/vrne/vrnint...dElemFormat=gifhttp://www.vicroads.vic.gov.au/vrne/vrnint...dElemFormat=gif

4. Lighting Requirements

They shall be non-triangular and fit within a circle 200 mm in diameter and shall reflect a red light.

5. Grouping of Reflectors

May be grouped with any other lamp, and it may form part of the lens of rear red lamp.

Direct link. Enjoy...

  • 5 months later...

To drag this up, I just thought I would let you guys know that I have been pulled up 3 times since I chucked these in and cops said nothing... 2 were nightime bretho's - both cops popped bonnet, checked vin number and let me go. Day time was speeding but was only 1 point offence.. but yeh, never had anything said about it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • As long as its NOT a HyperSHITtune, youll be fine.
    • First time visitor and currently getting ready to start work on my HK Premier.  Its all stock, 186 with 3 on the tree.  The only mod i have right now is extractors.  I am hoping to get some guidance on slightly modifying the engine to bring a little more power. Just going for a nice, comfortable cruiser.  The car is very straight, however i have been out of the country for 20 years and its been gathering dust at a family farm.  Will be doing quite a bit of body work to cut out some small rust areas (frnt quarter panels and a few other small bits) and fix up the paint.  Will be redoing the interior (its currently black and the seats are in real need of recovering and respringing the driver side (its front bench seat).  The dash needs a little TLC, but no real damage.  As my heater has degraded I am considering fitting something after-market that will be both heater/AC (recommendations here are always welcome). Wanting something discrete that will allow me to use the same controls and not be obvious once inside the car.   For the engine, i have been told i could consider upgrading my cam (imagine i would need a new head as well) and putting a new carby (currently the original stromberg).  However not sure what is going to be the best route.  Would certainly welcome any comments/suggestions.  As  a final step I am looking at changing the wheels. Current hubcaps are in dire need of refurbishment or replacement (imagine its a bit like hens teeth).  Thinking of some clean/classic looking mags (7-inch should be more than enough - not going for a large change in look).  Welcome any comments/advice and of course any questions. 
    • I got the ARC M079 due to the space constraint.  Been running mint for the last 3 years.  Plazmaman also seems like a really solid choice but not used myself.    Hunt around for a better price but this is what I have - https://www.rhdjapan.com/arc-brazing-intercooler-smic-m079-bnr32.html
    • Wanted to follow up on this. Did you end up getting the M073? Still deciding on what to get between nismo m073-79 and plazaman.  
    • I was just watching these boys up in QLD AWD'ing their S13 too.  
×
×
  • Create New...