Jump to content
SAU Community

Recommended Posts

Dont think there is a bearing in it either. I've had mine off using the SK DIY timing belt replacement. AFAIK it is two parts bonded together by rubber.????

Ther is a place at 17 Mile Rocks that has Stagea bits. They are in the Yellow Pages. A bit EXXY though, but close.

the only thing i have ever see go wrong with a harmonic balancer is the rubber bonding seperating or the key way flogging out

sounds a bit suss if you ask me

and there is no bearing on a balancer they must be talking about the idler for the timing belt which should always be replaced with the belt

Further to my last i dropped in and inspected myself.

Timing belt had dropped a tooth, timing bearings made the sound of sand when turned, harmonic balancer interior rubber was perishing.

So i went to just jap, and ordered the following

- Gates Racing timing belt kit

- HPI clear timing belt cover (bling bling)

- Ross Tuffbond harmonic balancer

Total cost $1028.70 with a 10% trade discount!

Kinda lucky in a way i caught it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That looks good, but I think you're going to need much beefier side skirts now.
    • They are daft and there's a reason it never caught on. Steering feel? We don't need no stinking steering feel!
    • I gotta pull you up on this. It's driving me crazy. A shutter is something that closes, like over a window or in a cmera. The word you want is shudder. That LSD is clearly f**ked. Take it to a diff shop and get it disassembled and examined by an expert. YOu might have plates welded together or something equally crazy.
    • Define "starting to fail". Wy not just rebuild them?
    • Check the Nistune doco. There are a few assumptions being made here that might not be valid. I will list the things that occur to me: Base map. Base map for what? Base map for Z32? Then the cranking pulse width is probably wrong for an RB25. The extra 500cc of capacity might well be enough to prevent it from catching. Base map for RB25? I don't think you can load one of those into a Z32. You have to just make the settings correct for an RB25 in the Z32 base map. That is either K or the TIM to get the pulsewidth right. Loom. You bought a loom for an RB. And you plugged it into a Z32 ECU. Did you make sure that any iwre differences were swapped. From memory, there's at least a couple. And as per the others, I would suggest making sure that the fuel pressure is correct while cranking and that the injectors are actually flowing as expected. They really must come out and go on the bench, unless you do find that you have messed up as per above points. I would also suggest watching in Nistune to make sure that everything is reading correctly. That the correct binary flags are raised at the right time (like the crank signal), that there's no stupid values in K or TIM. That you have not got mismatched firmware for the ECU and/or a wrong image loaded.
×
×
  • Create New...