Jump to content
SAU Community

Recommended Posts

series 2 seats are great part from one little rip in the usual spot on the drivers seat :)

have a pair of series 1 seats in perfect nick

hey mate, what's the condition of the auto gear box and how much? Also looking for driver door including trim, window, window motor, pritty much everything attached to the door except the mirrows. hit me back asap

cluster has 130xxxks

auto box perfect condition $300 ono

door with everything $200 ono

thanks

Hey mate will and RB25 auto GB fit into a RB20i engine? If the door is silver then I'll take it for $150 with everything on it, otherwise i'd only want the window motor and door trim, for i think you said it was $50 on the listing.

Edited by Lex469
series 2 seats are great part from one little rip in the usual spot on the drivers seat :P

have a pair of series 1 seats in perfect nick

Hehe no probs, I was after a replacement driver seat because of that little rip which I have on mine too :-)

The entire shell is still complete minus running gear and stereo

chasing 3 grand complete with 5 months qld rego still on it

thanks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
    • Forgot to include this but this is the mid section of my steering rack that looks like it has a thread/can be turned with that notch mentioned in the post:
×
×
  • Create New...