Jump to content
SAU Community

Recommended Posts

z32s are 80mm and GTR afm's are 65mm

so they are larger and can physically measure more airflow

there is zero gain to fitting z32s other than being able to run more air through them

ie if your at 300awkw you wont gain power going to twin z32s

it will cost you a bomb however doing it

for GTR keep the 65mm shell and go for twin nismo afm's

these are 65mms and direct swap and it's a Z32 sensor inside the shell

so you get higher resolution in same shell and direct swap

yeah there is a changeover point where you peak 5v on the stock GTR afms and need to upgrade

the problem is it's a costly exercise so a lot of tuners have been able to strech the curve a bit

when you max them there is no harm done, it just means it cant show any more resolution

this means you dont use anymore load cells on the tune

if you max them at 6000rpm not a big deal

if you max them at 3200rpm a big deal and it ends up being a map sensor tune

when i say a map sensor tune, i mean the load axis never changes once you reach target boost

as map sensor is on pressure and boost is fixed by wastegate / boost controller

The modifications to the car are -5 turbos, tomie cams, power fc ,injectors,dumps ect.. the engine has just had a fresh build with forged internals.. i just want to get it all sorted before taking it in to be tuned.. what is your opinion? do them before it gets tuned?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just trying to get my head around this. At 5psi of boost, you turn on your wmi pump, and then you're using a 3000cc injector, to allow flow upto the actual engine, where you have your 6x200cc injectors and a 500cc injector. If the above is correct, what advantage are you obtaining by having the 3000cc injector blocking flow, is this just incase a line breaks between that injector and the motor you can stop flow immediately? Or are the 6x200cc and 500cc less injectors and just spray nozzle?
    • Welcome! New member myself, but I had an R33 back in 2002. Best advice I could give, based on my experience: if you're running the factory turbo, be very conservative with boost. I made the mistake of just fiddling around with the boost controller and cranking the boost for fun, and the end result was my intake pipes popping off frequently from the constant deluge of oil that was being blown into the recirc by the stressed-out turbo, which itself was siphoning oil from the engine and farting it out both sides of its centre bearing (or something to that effect). If I could do it all again, I would have gotten a new turbo and had a tune dialled in professionally and then just left it alone! Funny you mention the metal shavings in the gearbox, as I had the same thing - the probe plug (magnetic drain plug, essentially) would come out caked with shavings. At least it was doing its job. Not sure if that's just sacrificial wear and part of the deal, or if my gearbox was shagged, but I wasn't abusing it. Enjoy the R33 - they're a dying breed, and if they weren't $35k+ on CarSales in Queensland, I might have picked up one of those again, instead of the 370GT I own now (though I'm loving the 370GT, that big 3.7L V6 just hits different).
    • Howdy folks. I owned an R33 back in 2002, which was thoroughly beyond my capacity (financially speaking) to maintain/insure, so we parted ways in 2004. Fast forward 21 years (to literally yesterday, in fact) and I'm now the proud owner of a 2007 V36 370GT. I'm happily surprised by how much power the VQ37VHR makes, compared to the RB25DET, considering the latter is turbocharged. I had planned to add a turbo at some point but I'm on the fence about whether I'll even need it (though I do love the sudden onset of extra torque). Any other 370GT owners around the traps, I'd love to hear about your experiences with this car (good and bad).
    • Perhaps the answer is... more jacks!* *proper jacks must be used.  
    • I NEVER think about using a scissor jack unless there is absolutely no other alternative. f**king things are dangerous, annoying and stupid.
×
×
  • Create New...