Jump to content
SAU Community

Recommended Posts

you can have your 1337 but i am 77331 so there.

yesterday i was probably actually doing some work :roll:

Wednesday and Thursdays are the "i'm officially getting paid by the hour so better work a bit harder" ...whoring must be kept to the minimum.

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

yeah, gordo I was hell busy this week and today is the first real chance I've had to whore. Are you moving that block out of your car on saturday or sunday this week. I might come around to give you a hand. You're only about 5-10mins down the road from my place.

charly: you'd have to probably talk to me to do that.. or shall we just communicate in sign language? But yeah, come one, come all. Not sure who gets the free slab though - maybe i should make it a survivor style challenge :P

I think i said 1pm Sunday would be a good time.. If we have enough people, may not even need special stuff.. May just be able to stand in the boot and lift it out

wouldn't an 8 be the land of herniation if you you were doing it without any mechanical help?

people help me out, is there such a word as "yous" or "you's" or might that just be an indication that the person that typed it has no grasp of the english language? It's bad enough when someone says it, let alone when they type it.

example: "you's decide what you're doing now"

yeah.. i think people have serious problems when they bring serious grammatical problems into a typed form.

They must do it deliberately.

well i got my r33 bill.. i am officially poor as all hell (yet again)... as in last few $ to last me a week poor

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...