Jump to content
SAU Community

Recommended Posts

It is just under the brake booster and even though it looks easy to remove it often is far from it.

Due to the amount of heat in a Skyline engine bay the hoses become hardened with time and stick to the filter and are hard to break the seal on (my GTR is a total pain to replace).

If you have a hose remover it will be a bit easier if you can get it in there - good luck.

Hi Where is the fuel filter located on a R34 GTT, there is a filter in the engine bay but it looks to easy. Is there one hiding somewhere

that is the one. don't let its easy location fool you. as victory said, the hoses can be a pain to get off. also make sure you remove the fuel filler cap (and leave it off till you are done) to release the pressure from the tank otherwise fuel will keep flowing out

I forgot to mention that you need to de-pressurise the fuel line before you remove the hoses. Start the car, remove the fuse for the fuel pump (located in the boot for a R33 not sure about a R34) and let the engine stall from lack of fuel. Otherwise you will be showered in fuel when you remove the line.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
    • Thanks for the replies everyone. Definitely a coolant push. Oil catch can is empty and always has been. As the engine is out now I'll be having a good look over things. I do have some detonation on the piston tops from a trigger issue back about 5 years ago. I felt it and shut off then bought a new ecu and changed the trigger. Never been an issue since. It never hurt the power, its made almost 80hp more since that incident but I will pull the bearing caps to take a look. If the bearings are damaged I will do a bottom end refresh. Head is being re conditioned at the moment and the block will be cleaned and checked to ensure it's flat. I'll go with a kameari gasket and see how it ends up. The other thing I'm not super keen on is the cylinder colours. I suspect this is from the inlet manifold. The plan will be to put it back together, retune and then stick a plazmaman billet inlet on it and retune. I'm happy with the power, if it makes a little more, then great, but I would rather just make everything more efficient at this stage.
    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
×
×
  • Create New...