Jump to content
SAU Community

Recommended Posts

Hey mate sure these arent

Garrett 2860 -7 or something with HKS Actuators???

Both front and rear garrett housings???

Thought HKS Had at the Very minimum HKS Cast Exhaust Housing and some variations had hks front housings???

I know my Previous 2530 had garrett front & hks rear housings...

Also are you in Kuala Lumpur Malaysia???

GT-SS's have no HKS markings on them.

They are only Garrett markings, and are identical to Garrett "-9", except for the actuators which HKS supply, are uprated.

Hey mate

Where are you located?

How many Kms have the turbos done?

How much shaft play is there?

Cheers

Malaysia

5000km run.

Shaft is still in good condition.

I had ask workshop to check this turbo.

good condition.

Edited by EWKC

GT-SS's have no HKS markings on them.

They are only Garrett markings, and are identical to Garrett "-9", except for the actuators which HKS supply, are uprated.

Thank you Mate.

Finally you trust me. I am the owner of this turbo. That guy is just buy from me and sell here.

Hey mate sure these arent

Garrett 2860 -7 or something with HKS Actuators???

Both front and rear garrett housings???

Thought HKS Had at the Very minimum HKS Cast Exhaust Housing and some variations had hks front housings???

I know my Previous 2530 had garrett front & hks rear housings...

Also are you in Kuala Lumpur Malaysia???

Yes. i am from malaysia. but not kuala lumpur.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
×
×
  • Create New...