Jump to content
SAU Community

Recommended Posts

so got my r34 gt - only thing on it is an exhaust - and there is no snorkel from the air box - just a hole in the bottom of the air box.

i can either

A - try and get a snorkel (this is preferred) - any one know where i can get one, how much. is thee a negative to just leaving it the way it is?

B - get a pod filter ( pros and cons? )

ideas?

Link to comment
https://www.sau.com.au/forums/topic/351099-r34-snorkel/
Share on other sites

Okay well the obvious answer to this question is get a pod :-) but make sure it's shielded either by a box or on the pod itself to save you hassle from the defect patrol. But if your going down the line of a pod you may as well do a full cai to see the full benefits.

But as you have said you would prefer te oem snorkel you have really two options

1: go to your local nissan dealer an order one brand new that is the more expensive way.

2: you can go to a wrecker and there are lots around and you should be able to get one quiet cheaply.

Also The only downfall of leaving it off is that you will probably get more hot air from the engine bay going into the intake as the snorkel takes the air from right at the front of the car before it can get heated up to much.

Hope it helps :-)

Link to comment
https://www.sau.com.au/forums/topic/351099-r34-snorkel/#findComment-5633954
Share on other sites

  • 3 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...