Jump to content
SAU Community

Recommended Posts

post-62518-0-35459300-1295664579_thumb.jpg

expressions of interest at the moment.

have my daily drive 92 r32 gtst 2dr that i am thinking of parting with, either whole, swaps or parts. dont know yet. lol

5sp rb20det with original hicas and is abs optioned, though atm its disabled.

approx. 175k on the clock (120k engine put in at 151k) and gearbox replaced bout 5-10k ago

had gates timing belt and rear main seals done before replacement engine installed.

stock clutch pressure plate reworked to heavy duty

r33 gtst rims with goodyear f1's on but both front ones need replacing due to too much camber, RHR rim has flatspot. changing on some 2nd hand tyres on tuesday

bonnet needs sanding and respraying

has front mount intercooler

stock suspension, think one rear one is leaking, front and rear strut bars.

gtr steering wheel thats worn around the outside

interior trims fair condition. door trimming need to be glued back on, speaker covers wont stay on, rear quarter glass trimming coming off.

hood lining good

rear seats in good condition

drivers seat worn through on outside edge, passanger side good

the car is registered atm and can be driven no problems.

am interested in trades, swaps, offers, whatever. just send me a pm with what u got and i'll get back to u

a clean r31 manual would be nice. let me know

additional pics are available and will be sent if interested

as i said before EOI at the moment but if the offer is good it can be yours

Located at morayfield, qld. bout 40 mins north of brisbane city.

Link to comment
https://www.sau.com.au/forums/topic/351316-eoi-r32-gtst/
Share on other sites

anyone interested?

interested in swaps for - r31 skyline

- motorbike / motocross

- anything interesting (let me know what u got)

Edited by R31 To R32
Link to comment
https://www.sau.com.au/forums/topic/351316-eoi-r32-gtst/#findComment-5647488
Share on other sites



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...