Jump to content
SAU Community

Recommended Posts

Im having troubles with my s1 r33 when i stand on the accelerator it reacts normaly but when it changes to second gear the revs fall to 3k and wont accelerate any more.... could it be a form of limp mode...

also when it changes from 1st to second... before it cut the revs it would hit limiter for a second before it pulled second... not shure if this in normal...

Link to comment
https://www.sau.com.au/forums/topic/352373-auto-doin-weird-shit/
Share on other sites

have you checked your oil in the trans.

Whens the last time you've done a service on it?

is there a trans oil cooler? sometimes in the hot weather it decides to overheat and the trans becomes noticably sluggish.

and judging by your trans flaring between 1st and second,it sounds like your 2nd gear clutch plate is completely worn. Looks like a rebuild mate.. or a manual conversion!

If your doing a trans oil change, make sure to ONLY put whats on the dipstick, or a fully synthetic oil like nulon AT Tran fluid. I'm pretty sure 33's runs Re5 4spds?

Edited by AaronNM35

Yer mate could be a rebuild... it was serviced with new oil like last month... arnt those gearboxes electronicly controlled could it have somthing to do with the TPS because the way it cuts the revs is super weird... and if its worn meh ill just drive it till it pisses me off lol its only a daily i have a track car to go fast...

yeh there is a trans ecu talking to your Main ECU.

so if it notices a fault in the trans it can actually talk to your main ecu telling it basically not to rev so hard so it can avoid the trans slipping.

when they did the service they may have used Dextron III which isn't the best fluid for an RE5 trans. it needs to be what on the dipstick., or basically goodbye transmission.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
×
×
  • Create New...