Jump to content
SAU Community

Recommended Posts

Hi all

Just after some advice on something thats been an intermittant problem on my 34 GTT

out of nowhere (meaning i havnt touched anything) the power seems to drop when the brakes are applied, or even more obvious when the indicators are used.

in some cases im just sitting at the lights and everything goes dead

i know theres a short somewhere.. but where do i begin?

Link to comment
https://www.sau.com.au/forums/topic/356998-voltage-droppinglights-dim/
Share on other sites

just did then. the car has been sitting still overnight so nothing could have shifted around (loose wiring) and it seemed fine when it came to test it.

the voltage when started was at 14.5v

only thing i can think of is when it happens again, pull over and give the alt a whack

Hi all

Just after some advice on something thats been an intermittant problem on my 34 GTT

out of nowhere (meaning i havnt touched anything) the power seems to drop when the brakes are applied, or even more obvious when the indicators are used.

in some cases im just sitting at the lights and everything goes dead

i know theres a short somewhere.. but where do i begin?

if its showing 14.4 running and stays that high, your battery is farked most likely , the current holding on the battery is gone.( interenal corrsion of the plates ) your battery might say 12v off, but when you crank it it's dead, NO AMPS (Current )

or corrsion on the terminals ?

loose bolts at the terminals?

if you still have one of those little ass battery from japan , bin it and buy a real one . DO NOT WHACK YOUR ALTERNATOR, it could only just damage it !!!! the old school hitting the starter fix doesn't work on it

you can spray it out with electronics cleaner IF its oiled up like hell, but beware , some cleaners can melt plastic /paint or ruin the alternator is used wrong or while running.

ground your battery with an additional 4ga cable to the bracket bolts holding the alternator and zip tie the wires to keep them from hitting anything, your car will thank you and charging will be much better.

power electrons goes from negative to positive, not the otherway around like common thinking sugguests.

the grounds for 90% of everything in the rear of the GTT are behind the rear seat back on both sides connected in a star fashion. doubt its a ground unless at the battery or something new installed wrong ?

if its showing 14.4 running and stays that high, your battery is farked most likely , the current holding on the battery is gone.( interenal corrsion of the plates ) your battery might say 12v off, but when you crank it it's dead, NO AMPS (Current )

or corrsion on the terminals ?

loose bolts at the terminals?

if you still have one of those little ass battery from japan , bin it and buy a real one . DO NOT WHACK YOUR ALTERNATOR, it could only just damage it !!!! the old school hitting the starter fix doesn't work on it

you can spray it out with electronics cleaner IF its oiled up like hell, but beware , some cleaners can melt plastic /paint or ruin the alternator is used wrong or while running.

ground your battery with an additional 4ga cable to the bracket bolts holding the alternator and zip tie the wires to keep them from hitting anything, your car will thank you and charging will be much better.

power electrons goes from negative to positive, not the otherway around like common thinking sugguests.

the grounds for 90% of everything in the rear of the GTT are behind the rear seat back on both sides connected in a star fashion. doubt its a ground unless at the battery or something new installed wrong ?

agree with most but not this bit, if the engine starts ok and the problem is only intermittent i wouldnt think battery. the alterator should be able to supply those sorts of power levels without voltage dips due to indicators or lights even if the battery was stuffed. i would be turning a/c fan on max, all lights on etc then check the voltage at battery and alternator. should be 13.5- 14.4ish and less than 0.5v difference. and yes do NOT whack the alternator.

a farked battery will do that. doesn't matter what the charge voltage is. if it has a collapsed cell (IE short) then it will take an alternator with it.

don't belt the alternator...

yes my money is on dead cell or weak one,

and or corrosion on the terminals, loose bolts holding clamps.

voltage regulators fry when the cell shorts, or jump starts gone wrong.

they can go the other way too, and overvoltage the car as well, which kills the ecu, battery, fuseable links, relays, etc. and other lovely items. high rpm tends to do that one, my bridgeport RX7 killed off many alternators some lasted 1 rev to redline before death . just a good thing it was a weber not fuel injected car.

i still stick by my comment, not saying your wrong about the battery as wierd things happen and we are only diagnosing over the interwebz but i think if there isnt any shortage of power starting the car, then i would imagine indicators should be piece of cake. dead cell batteries usually have a standby voltage around 10v so will start but sound sad.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Is it alright to top up with just another green coolant?
    • thanks GTSboy. My confusion at the moment is i am trying to locate the ignition, ECU battery power and the ECU negative The closest thing i can find is the for the S15 on Page 8 of the Wiring Specialties web page https://drive.google.com/file/d/0B9F33_M_GgENQnZ6STMxVmVNd1E/view?resourcekey=0-eZ4nNRwRoqa1qvKlWWHm8A I cannot find the same diagram for the R33 RB25DET Series 2 dash plug pin out.... Do you know what the Pins? or know where i can find the same pinout diagram for the RB dash plug? Thanks for the advice on the box... i like a 6 speed so might be on the lookout or the box now.. a topic of discussion for another post...
    • Will have a look at that. I cant see any leaks 
    • Put another overflow bottle (ie, a 1.25 coke bottle or similar) under the overflow hose and see if it is being pushed out there or if it is disappearing into the engine.
    • Staring on a stand is no issue. You just have to wire everything up, give it fuel and cross your fingers that the stand is robust enough. Arranging the inlet plumbing is often the hardest part, without any surrounding structure to hand some of it from. No need for coolant if you only want to run it for <1 minute. As to the gearbox - I think the little Aisin box is a bit stronger than the other small Nissan boxes that went behind SRs, but I wouldn't be too keen to test its limits with the torque of a boosted 25. I don't know if you can retain the box and the tailshaft. The box won't connect to the RB without an adapter of some sort, which is either a plate that will push the engine forward (which is not good for fitting it into the bay's available space) or push the box back, which messes with the box position and tailshaft length - OR - cut and shut work on the bellhousing, which is a long way from "least modification". I'd be buying a new 370Z 6 speed or similar, doing what has to be done to that to make it fit RB (ie, cut and shut bellhousing) and the requisite tailshaft custom/mods.
×
×
  • Create New...