Jump to content
SAU Community

Recommended Posts

  • 3 weeks later...

My build is in progress :) bought a worked and complete head with all the goodies, dan from erd is going to build my engine, happy all round :)

Nicely done! That motor should be wicked after receiving the Dan touch.

No I didn't buy it, rather spend the $2200 getting the engine finished first. And after seeing the 6266 result on the 26 engine punch out 500 rwkw or what ever it was I'm deciding between different turbos again

it will be interesting to see how long that 26 of simons lasts with the 6266. He is chucking a lot of boost at it thats for sure. Should make a build thread!!!

What Ideas do you have for the engine at this stage. Do you know what injectors, Manifold, Plenum etc you are looking towards?

I have a front facing plenum with 90mm throttle body

Engine will be forged with cp pistons and spool rods, arp main, rod, head studs. Keeping vct inlet cam as dan made a good point about it. Head is built with new upgraded parts.

Fuel system will be 2 044 pumps from surge tank with nismo intank, 2000 Id injectors. Dash 8 fuel lines. I want the surge tank mounted under the car though for simplicity running flex fuel setup

6 boost t4 split pulse manifold, 4 inch turbo back exhaust

Will be pushing what ever turbo I get to maximum capacity with what the fuel can handle.

I will start a build thread soon.

How's your car going to Scott? ANy dramas?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • 310mm rotors will be avilable from Australia, Japan, and probably a few other places. Nothing for the front can be put on the back.
    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
×
×
  • Create New...