Jump to content
SAU Community

Recommended Posts

Item Summary: nissan skyline r32 gtr 400 awhp black with gold pearl strong motor quality mods.

Location: nsw, sydney area.

Condition: Used

Reason for Selling: not needed never drive it. need to pay off loan.

Asking Price: 17,500 ono.

Delivery Methods: PickUp

Contact Info: email [email protected] or msg 0424135266

Extra Information:

NOW WITH 12 MONTHS REGO NOTHING MORE TO SPEND JUST DRIVE AWAY.

nissan skyline r32 gtr. 1990 model. 120,000k's rebuilt at some stage was told it was done in japan just before it came over in 2005. can tell by the different gaskets.

Metallic Black with gold pearl, has molded front n1 air ducts in the front bumper looks much better then normal cut out ones.

600x300x100 Front mount intercooler,

greddy larger intake plenum.

Apexi Power Intake with new Apexi filters

Z32 airflow meters

kaaz 1.5 way lsd. still very tight.

Splitfire ignition coils,

Twin Garret ball-bearing turbos 360hp rated each

Nismo front and rear strut braces

nismo front and rear top suspension arms

Sard adjustable fuel pressure regulator

660cc Denso fuel injectors

Apexi Pro Power FC computer, not the normal power fc this one can activate launch controll and rev limiter cuts fuel and spark which in others that just cut one can cauz detonation.

Apexi FC boost controller

Tein coil over suspension front and rear

Nismo front and rear adjustable trailing arms

Walbro intank Fuel pump,

17x9.5 Nismo Hasemi Wheels with new Toyo 235 rubber on the rear

Mines 320km/h Dash

Greddy engine oil cooler

Full HKS exhaust, dump pipes, front pipe into 3.5in system, pretty quiet.

Exedy Twin plate clutch

HKS hard pipe intercooler piping

Tomei Hicas lock

New battery and alternator

Engine and gearbox has just been service with Motul Full Synthetic oil

has larger cams not shure on specs but idols a lil rough can check them after deposit is taken. dont bother me not knowing what they are.

was dyno'ed by last owner at 405hp at all 4 wheels.

has been a good car but not needed at the moment and just seeing what else is out there.

inside is stock. has a jvc cd/mp3 player.

running in 2wd at the moment as the front diff let go have already purchased a new one and all new bearings just havent got the time to put it in but will be done before getting sold.

also has brant alarm with central locking and imobilizer.

has a nismo plate in the engine bay and was told when they came out nismo took some of them and did upgades ont hem like a bigger clutch and suspension work etc.

for more info just ask.

price is negotiable. SWAPS FOR A SMALLER CAR AND LOTS OF CASH. no civis or any other front wheel drive 4 cylinders. im in no need for a car so cash is prefered.

post-64730-0-03182500-1300310718_thumb.jpg

post-64730-0-86831000-1300310731_thumb.jpg

post-64730-0-60943000-1300310734_thumb.jpg

post-64730-0-07809200-1300310740_thumb.jpg

post-64730-0-58644300-1300310760_thumb.jpg

post-64730-0-76644200-1300310778_thumb.jpg

post-64730-0-11651400-1300310791_thumb.jpg

post-64730-0-27789700-1300310811_thumb.jpg

post-64730-0-78189300-1300310830_thumb.jpg

post-64730-0-78582500-1300310848_thumb.jpg

  • 2 weeks later...
  • 2 weeks later...

Mate the nismo plate has nothing to do with it being modded by nismo.

All it represents is that it had a nismo twin plate or single clutch, I know coz I have the same plate that came with my old clutch

Yes the plate is for the clutch. The old owner informed me that the car was taken by nismo, upgraded and then sold by them. Just what I was told. And the front diff is still not fixed have done 2000km in the car in over a year and didn't need it done personally. Will be done before sold.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...