Installed Single Mass Flywheel

[DAS KAMU]

installed single mass flywheel now wont start - only turns over

there is only one wat to install the flywheel due to the locating dowel

it is an exedy single mass flywheel kit in a 350gt coupe 6 speed

the only thing im guessing it could be is the crank angle sensor located in the gearbox housing?

does any one have an idea

[scathing]

Probably the crank angle sensor. I've heard of a couple of people having this issue after doing the flywheel, and its inevitably the CAS.

[zei20l]

+1 on the crank angle sensor. had a VQ25DET that wouldnt start as the wiring the the sensor was damaged. check the plug, it may not be plugged in or dirty

[DAS KAMU]

oh i see

[DAS KAMU]

wow after reading up on these thing it happens heaps?!

mostly in the u.s though why are they so delicate

ill order one and stick it in

its odd though that most people say it happend to them checked the sensor and there was no visible damage it just kind of stopped working after taking it out

but upon reinstalling it just cranks and wont start

however when they put a new sensor it works ? glad my 32 is much easier

[Touge Kyousou]

wtb your 'slightly used fleshlight'

PM me

[scotty nm35]

Did you put the pickup ring on the back of the flywheel? Most of them require you to remove the ring from the stock flywheel and fit it to the new one. The sensors are prone to damage though.

[DAS KAMU]

Did you put the pickup ring on the back of the flywheel? Most of them require you to remove the ring from the stock flywheel and fit it to the new one. The sensors are prone to damage though.

for the starter motor? then yes

[DAS KAMU]

the cas should hit my mechs door soon

[scotty nm35]

for the starter motor? then yes

The metal pickup ring for the crank sensor is bolted to the flywheel, or in your case isnt?

[DAS KAMU]

replaced cas

now works

how shit are these things

[DAS KAMU]

on a further note dual mass flywheels are a pretty dumb idea

the one on this car was shedding shrapnell and could move the centre by hand independent of the outer part

if you have a dual mass get rid of it