Jump to content
SAU Community

Recommended Posts

i like how the high beam lights on the VX drop down a little bit. i also prefer the clear style tail lights of the VX. i had a vx with a vt hsv style front bar on it. got the bar off a mate for $80 as it was damaged. did a bit of alterations to make it fit the vx headlights. it is my favourite of the HSV front bars, but they are hard to get now as everyone sells later model front bars to fit the earlier models which look like crap.

Were abouts would I fine hail damaged cars and any examples of what I can possibly get ($4000 now the limit)? Also found a 03 mirage with 110k for 4k with slight ding in the back and a few slight scratch marks. They any good?

Were abouts would I fine hail damaged cars and any examples of what I can possibly get ($4000 now the limit)? Also found a 03 mirage with 110k for 4k with slight ding in the back and a few slight scratch marks. They any good?

I think the getz is > than a mirage

But I'm not much of a mitsubishi fan besides the evo ...

Not too sure about where to find hail damaged cars .. but on carsales theyll usually advertise that the cars hail damaged .. and you'll notice a significantly cheaper price tag too!

Gumtree is always cheaper than carsales though it seems

Also get hold of a quokka .. lots of cars there

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...