Jump to content
SAU Community

Recommended Posts

Has anyone really wondered why our R30 Skylines slip through the air so well?

Drag, down force, design etc all go to fuel efficiency, but do you know there is only one (1) Nissan with a better drag coefficient (Cd) than the R30 Skyline.

Cheers, D

Link to comment
https://www.sau.com.au/forums/topic/371296-slippery-r30s/
Share on other sites

Nobody got any ideas????????

I find this amazing!

Just imagine the McLaren F1 has a worse Cd than the R30!

The R30 has a drag coefficient (Cd) of 0.27

The 2007 GTR has a drag coefficent (Cd) of 0.27

The 2010 GTR has a 1/100th of a point better Cd at 0.26 and is the slipperiest Nissan ever built.

To put this figure into a bit of perspective, the R32 GTR has a Cd of 0.40, the R33 GTR 0.35, 280ZX @ 0.385, 1983 Z31 300ZX has 0.30, 1989 Z32 has 0.32, G37 Infinity coupe has 0.31 and both 350 & 370Z 's 0.30

Cheers, D

Link to comment
https://www.sau.com.au/forums/topic/371296-slippery-r30s/#findComment-5926100
Share on other sites

Better than you.LOL

I said RMR, ie, Hatchback. It aint an R30.:pirate:

Humble apologies my dear friend, but my wind tunnel test results don't differenciate between an EDR, KHR, RMR, or any other derivative, because I guess at the end of the day THEY ARE ALL R30's or have I got this wrong to :cheers:

Whilst I'm here does anyone know why the 2010 GTR has a slightly different Cd to it's predecessor?

Cheers, D

Link to comment
https://www.sau.com.au/forums/topic/371296-slippery-r30s/#findComment-5928154
Share on other sites

what's the CD for R34 GTR ... i am guessing not very good number

Just off the top of my head I would assume it would be quite reasonable, but I will check on it to confirm, but as the R34 was designed off the R30 I would think it might be quite good as I said.

Cheers, D

Link to comment
https://www.sau.com.au/forums/topic/371296-slippery-r30s/#findComment-5928161
Share on other sites

  • 5 months later...

Guys,

The Cd number is relevant, but it's only part of the story...

The actual drag force is calculated by D = Area x Cd x 1/2 * rho * (velocity)**2

rho is the air density and velocity squared is just that, speed mulitplied by itself.

The half rho v squared part will be the same no matter what the vehicle, so the difference in drag force comes down to Cd mulitplied by frontal area.

The McLaren has less frontal area than a Skyline R30 and so it will have a lower total drag force.

cheers,

Howard.

Link to comment
https://www.sau.com.au/forums/topic/371296-slippery-r30s/#findComment-6182904
Share on other sites

I hear ya hugh....

I always felt after 160km my old hatch would just nearly roll to 200... (off the dial and then some...)

shit i miss that car...

It will and I do too. Miss it.

Link to comment
https://www.sau.com.au/forums/topic/371296-slippery-r30s/#findComment-6183093
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
    • Probably. I take it that they are also mentioned to be for R34 Skyline? For example.... RDA has that part as RDA7957. I have the dimpled and slotted version of that on my car https://www.ebay.com.au/itm/285518478694?srsltid=AfmBOopKxMuAFpsxZJdB1cam4D5RAj1f9yJyOttPZLAwXVNCOiwlhrIy This is DBA's top one piece equivalent https://www.ebay.com.au/itm/364246686631?srsltid=AfmBOorbb0XHQgqTvZLgQPhg70nqJtGvdojKnugum3O2LFSr2h-obp8D  
×
×
  • Create New...