Jump to content
SAU Community

Recommended Posts

  • Replies 121
  • Created
  • Last Reply

Top Posters In This Topic

hey Joey I won't be there till about 11am or so, but you are right to use the carpark, you don't have to wait for me.

Once I am there I will be able to provide power and the necessary break facilities.

Bit of advice for those showing up.... bring a drink or something to eat as there aren't really any corner shops close that are open on the Sunday around here.

i might be dropping by to help Shane do his fuel pump while strutto does his S-AFC..that is if i'm not too hungover :P

sau workshop in full effect :D

in that case i'll bring the r30 as i need some one to look at the fuel pump wiring to the ECU!!! lol.. :D just jokes!

if the same as the R31's you have to use some sort of relay i hear to change the signal. There is instructions on r31skylineclub.com if you haven't already been there tried that.

if your talking to me then the r30 i have now runs a r32 rb20det, a little off the topic, but i'll have a look anyway :thumbsup:

Spectrix, I got a whole lot more ideas what we can rice green, we basically sat around last night waithing for the nebo run boys to get back and got some aWeSoMe ideas :P

1. Bonnet wiper squirters

2. "SKYLINE" on the back just the writing

3. Wipers

4. Side indicators

5. Front Grille

And maybe at a later stage:

Wing

Side Mirrors

MuUAhaH aHh Ah hA h aH HAHHAH A HhaH A hha haaa

Call meeeee, king of the rice boys!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...