Jump to content
SAU Community

Recommended Posts

mandrel bent 2.5" mild steel custom made system. include 0-2 extra mufflers in the middle of the system, oval muffler on end.

will cost around 600 or so. just go to a local exhaust shop and get one made up.

this topic was covered in a previous post .... MANY times, in fact there was one just yesterday if you had bothered to read.

There is five different threads about exhaust systems for non turbo skylines on the first page of this section.

They need to put a sticky or something in huge bold writing because every single retard comes into this section of SAU and asks the same question.

gain performance through exhost?

easy mate, just make the piping as big as possible, 2.5" has been suggested cos its just too expensive to buy enough metal to make 5" piping. bigger piping = tons of air flying right through.

also sticking a whopping great big cannon will make your cars exhaust system be just as powerful as what the name suggests - A CANNON

your skyline will now fly

okay il be serious now, exhaust isnt a very great way to make more power. in fact anything n/a isnt a very good way to make more power.

this is why you are advised to SEARCH.

in fact, had you searched, you would also have found out that extractors are nastily expensive for the relatively little power they give unless you like to be in mid-high rpm ranges, and even then its still nothing special.

and if you at least did not say "cbf searching" - you would have at least avoided my sarcasm.

im picking up a nismo 2.5" cat back tonight. ill fit it tomorrow and tell you guys how the car feels.

im guessing it should be pretty good since it is a genuine nismo item for an NA

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sane enough. Remove the roof liner, because the acid will go everywhere.
    • Thanks guys, I really appreciate the help and experienced opinions.  I have spent a lot of my life working on boats so I'm pretty good with fibreglass. I'll take everybody's advice in here;  I'll cut a little more of the 2nd layer away as it's a bit crunchy rust and also it's sitting high now. Then I'll wire brush it all a bit to get off anything loose, then I'll soak the bejesus out of it all in rust converter. I'll make sure to get a little hose piece and feed it into all the holes and gaps between the roof layers. Then I'll fibreglass up the holes.  Then I'll get a pallet of filler and mix it with 3 buckets of hardener and hope that is enough to build up the roof corner.  Does that sound sane? Is one type of filler better than others for this?
    • My goals for it atm are to get it registered, respray and some mild power gains eventually... I picked up the car from an elderly gentleman near the border of NSW and VIC, its honestly a bit rough and looks like its been driven on a farm (because there was so much dirt underneath). Last week I dropped the subframe and emptied the old fuel out + added a new fuel pump (think the old one went bad from old fuel). Now I'm onto fixing a coolant leak at the rear of the engine + adding a new radiator as the old one is corroded. After that i have a new bumper, coils (as the old were leaking) and lots more
    • Welcome buddy! Plenty on here and YouTube. What are your plans for it? Good luck with the Rwc and Rego bud!
    • Love this so much! Please post a photo when you have a bike on the trailer.  I was a little bit worried about having a tow bar on the Skyline, but having it hidden behind the number plate is genius
×
×
  • Create New...