Jump to content
SAU Community

Recommended Posts

I have recently bought a neo rs4s so will be selling my S1 c34.

I was just about to get it tuned with nistune but dont need them anymore so i'm selling 2 loom/ecu kits

Regarding the loom/ecu stuff:

The z32 ECU kit is nistuned and has a map in it for stock injectors and a z32 afm. I've had it running on my car (only in the driveway - i never got it tuned). The loom consists of a field harness (~$250) with a z32 loom spliced in. It uses the stock ECU for controlling the auto and some other functions. There is about 2foot of ecu wiring to allow you to put the z32 ecu somewhere convenient. I'd be after the most of cost of parts for this. There was at least 8 hours work as well. ECU - $120, Nistune - $250, Field Harness -$250, Z32 ECU harness $50. The parts added to $670 but i'll let it go for $550. It will cost you double this to get it made

$550

The R32 ECU kit isn't nistuned, but it came from a Kiwi4s4 who had a chip in it to suit his setup. It has a custom adapter loom made by someone in NZ. It isn't nistuned but has the socket soldered into the ecu to make nistuning a plug and play affair. I'm after 250 for this kit.

$250

Located in Campbelltown, Sydney

Link to comment
https://www.sau.com.au/forums/topic/379753-s1-stagea-remapnistune-eculoom-kits/
Share on other sites

  • 2 weeks later...
  • 3 weeks later...
  • 3 months later...
  • 5 months later...
  • 6 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...