Jump to content
SAU Community

20,000Km Overdue Service On A Gtr- What Should I Do? Engine Flush?


Recommended Posts

Not changing the oil for that ammount of time is bad, but it's even worse when there is a turbocharger or 2 involved, it's quite common oil seals (rear main being one of them) have deteriorated and all that is holding those seals together is the sludge from the old oil.

If you do the timing belt, do the whole 100,000km service (belt, tensioner + idler pulley, both cam seals and the crank seal, water pump).

Since the previous owner didn't GAF, I think these 2 are important: brake and clutch fluid. While these should be done for peace of mind: front and rear diff, transfer case and gearbox too if it's hard to shift gears or crunches gears.

As for oil go with something very detergent heavy, it might even be worth getting some cheap oil in the correct weight (10w40) and using it to flush out the crap before putting a good oil in.

It's very lucky the engine hasn't spun a bearing actually.

I'd be going the other way with the oil.

Get a cheap 10w40 mineral oil, and change it every weekend for 2 weeks. While running the mineral oil don't drive the car even remotely hard. Just run it up to temp gently and keep the revs below 4500. Especially dont flog it when its cold. The idea is you want to filter as much crap out of the oil system as you can, not have it bypass the filter and get to your bearings. Higher revs mean high oil pressure which results in some oil bypassing the filter.

After your 2nd quick change, then fill it with royal purple/motul or some other high quality synthetic.

Everything else you change and do will be determined by the age of the car, its level of tune and how many k's are on the odometer. Timing belts are a 100,000k item as are the tensioners. It would make sense to change the diffs, gearbox, transfer case, steering fluids and coolant just so you can start a logbook for the car's servicing. Then do the next service of these area's at 1/2 the due km's.

And in the meantime fingers crossed that nothing has been damaged by the neglect.

Agreed with GTRNUR, dont flush it with an actual engine flush, (i have seen those things loosen up too much stuff and actually damage the engine) use the likes of gtx and do regular filter and oil changes i went anal and did 2 changes in 300 kms so clocked 100km after the first one, dropped it then did 200kms dropped it and kept doing 200km cycles untill it started to keep it's color took about 4 all up, i also split the filters to see is any crap came through and there was none, once i was happy i put in 300v, and change religouslty every 3500km funny thing is that the oil now keeps it nice clean colour for some time before going crappy. I would'nt stress too much about it in that oil quality these days is pretty good to the extent that some manufacturers are recommending 15k intervals on turbo charged cars. but thats no reason to sit on it . might even pay to take the rockers covers off 20 min job and have a look to see if there are any chips of shit built up in there, that is always a good indicator to the rest of the insides.

I'd be going the other way with the oil.

Get a cheap 10w40 mineral oil, and change it every weekend for 2 weeks. While running the mineral oil don't drive the car even remotely hard. Just run it up to temp gently and keep the revs below 4500. Especially dont flog it when its cold. The idea is you want to filter as much crap out of the oil system as you can, not have it bypass the filter and get to your bearings. Higher revs mean high oil pressure which results in some oil bypassing the filter.

After your 2nd quick change, then fill it with royal purple/motul or some other high quality synthetic.

Everything else you change and do will be determined by the age of the car, its level of tune and how many k's are on the odometer. Timing belts are a 100,000k item as are the tensioners. It would make sense to change the diffs, gearbox, transfer case, steering fluids and coolant just so you can start a logbook for the car's servicing. Then do the next service of these area's at 1/2 the due km's.

And in the meantime fingers crossed that nothing has been damaged by the neglect.

yes a r32 GTR for $5000 i think its cheap :)

ok so im going to change the oil with cheap 10w40 mineral oil but how many kms should i do before i change it again with either the same cheap oil or good royal purple?

thanks soo much for all your help!!

yes a r32 GTR for $5000 i think its cheap :)

ok so im going to change the oil with cheap 10w40 mineral oil but how many kms should i do before i change it again with either the same cheap oil or good royal purple?

thanks soo much for all your help!!

$5K gtr??? :cheers:

nice work man!

follow the steps that GTRNUR posted..

Get a cheap 10w40 mineral oil, and change it every weekend for 2 weeks. While running the mineral oil don't drive the car even remotely hard. Just run it up to temp gently and keep the revs below 4500. Especially dont flog it when its cold. The idea is you want to filter as much crap out of the oil system as you can, not have it bypass the filter and get to your bearings. Higher revs mean high oil pressure which results in some oil bypassing the filter.

if it's a daily, change oil and filter this weekend, use it next week, drop the oil and filter that weekend and repeat for one more week.

then put good oil of your choice.

If not a daily, then replaice oil and filter, then put say 200km through it while driving as suggested above.. and drop it and repeat.

most of these cars weren't serviced properly in Japan anyway..

and you got it at a price where you could afford to go get an R34 GTR motor put in for like an extra $5-7K and still be in front.

5k gtr..... basic oil change not done in 20k..... no doubt every fluid will need doing sounds poorly maintained.... no doubt other issues will come up too....

Edited by rgr34

I'd suggest taking small steps with the car and don't buy anything expensive for it. For example: No synthetic oils.

You have a lot to establish before you go sinking any money into it. If you jump in with both feet trying to restore it to its former glory you could end up with a bottomless money pit very quickly. GTR's can be bottomless pits when they are in good condition, so imagine how bad a neglected one could be.

I'd suggest doing a hot compression test after you do the first oil change. This will give you some idea as to the health of the engine.

Oil pressure when its been running and is over 80 degrees will give you an idea of the bottom end condition. If it still drives ok, then drive it for the first week as is. Only once its proven itself a little would I then suggest changing the diff, gearbox, steering, transfer case and cooling system fluids.

I you jump in too quickly you might just be throwing money away on consumables you will be draining again when you start replacing the broken parts. If things start going wrong, and also if the shell is full of rust it would be worth considering wrecking the car and selling off the components. You will end up making your money back and then some.

Then go looking for another bargin.

I'd be going the other way with the oil.

Get a cheap 10w40 mineral oil, and change it every weekend for 2 weeks. While running the mineral oil don't drive the car even remotely hard. Just run it up to temp gently and keep the revs below 4500. Especially dont flog it when its cold. The idea is you want to filter as much crap out of the oil system as you can, not have it bypass the filter and get to your bearings. Higher revs mean high oil pressure which results in some oil bypassing the filter.

After your 2nd quick change, then fill it with royal purple/motul or some other high quality synthetic.

Everything else you change and do will be determined by the age of the car, its level of tune and how many k's are on the odometer. Timing belts are a 100,000k item as are the tensioners. It would make sense to change the diffs, gearbox, transfer case, steering fluids and coolant just so you can start a logbook for the car's servicing. Then do the next service of these area's at 1/2 the due km's.

And in the meantime fingers crossed that nothing has been damaged by the neglect.

id pretty well go with this but id change it 2k or so after you do the oil change with good oil... never hurts to put a fresh filter and oil through it

will a 15w40 mineral be ok??

Yes that will be fine. The main thing you are trying to acomplish is getting the built up garbage out of the engine.

So the pre-requisits to do this are:

No expensive oils unless you happen to own an oil field...

Use a new filter

Change every weekend or 200km as has been suggested for 2 cycles before switching back to synthetic

Dont rev it past 4500, and especially when cold keep the revs low.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sounds like you've got an interesting adventure ahead here with local support if you have trouble! My guess is that, unboosted, you will be OK with a small upgrade like -9. What will happen is that once the stock ECU sees more airflow than it expects it will add a heap of fuel and pull a heap of timing to be safe because it can't understand how it could get that much air without there being an issue. You will see clouds of black smoke and it won't pull hard through the midrange and top end. So, overall it will be a bit frustrating but should be OK. If you are still nervous set the base timing back 2o through the CAS, but it will be even more sluggish everywhere. As said above through...this is not my guarantee your engine won't be blown into a million pieces, leaving you looking for very hard to find parts A better idea is get a computer with logging ASAP, wire in a wide band O2 sensor and a use remote tuner. I've done multiple cars this way and while it is not as good as a specific tune on a dyno they can get it 90% right. I'd suggest if you can afford an R33 GTR these days you can afford an ECU and tune. And if you can't afford that you sure won't be able to afford the rebuild if it goes bad in the meantime,.  
    • Yeah it would be nice if someone took the time to put that sort of information together, but there are a lot of variations in looms. I think you are making this way hard for yourself if you just want to get it running....sourcing an SR20 with the right wiring will be a billion times easier than matching the RB loom to an S15 chassis. If you do end up going this way, you just need to trace every wire in the loom with a multimeter, 95% of them will go to a location you can confirm at the ECU.....and then post it up for the next person who needs it  
    • Just top it up with water, and keep a general idea of how much you added. It is normal for water to be pushed into and pulled out of the reservoir through the cap, and it should not be more than half full or it will be likely to overflow when hot. Any decent mechanic can do a pressure test of the cooling system to confirm if you have a leak. Keep in mind if it is only leaking a little and when hot it may well evaporate before you see it hit the ground
    • I'd ask the shop what they used and use that. Mixing coolants is sometimes OK, sometimes not, and you have know the details of each coolant to know whether it's a good idea or not.
    • Is it alright to top up with just another green coolant?
×
×
  • Create New...