Jump to content
SAU Community

Garrett Gt3082

Marcus89
 Share

Recommended Posts

Marcus89 Proficient

Marcus89

Posted
Posted

Bought this 3082 but am thinking of going even smaller after driving my mates rb25 180 with a GTRS on it.

There is no shaft play on the turbo but it has been used by the previous owner supposed to be in good working condition.

I paid $1000 for it but will let go for around $700.

Will get pics up today it has the 0.63 external wastegate rear housing on the turbo.

Am located in Brisbane could post if needed. Pm me and can give mobile number

Link to comment
https://www.sau.com.au/forums/topic/380483-garrett-gt3082/
Share on other sites
Marcus89 Proficient

Marcus89

Posted
  • Author
Posted

With the 0.63 rear housing it shouldn't be too laggy but it does choke the turbo a bit so will make a bit under 300rwkw from what i have gathered. With a 0.82 housing will make easy over 300 and the 1.06 housing will go to about 320+

Link to comment
https://www.sau.com.au/forums/topic/380483-garrett-gt3082/#findComment-6073516
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      Unpeeling the Orange

      By MBS206 · Posted

      If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      LOL, all of the CAI like Craig I just need to put a hole saw through my bumper Done and dusted, the car runs, which is nice, I'll take it for a spin when the weather clears up Just need to put the bumper back on for good
    • EndZee
      R33 Gts/-t Abs Module Wiring Schematic (not Gt-r)

      By EndZee · Posted

      Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • GTSBoy
      Boost cut after swap(RB25DET NEO) R34

      By GTSBoy · Posted

      Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
    • dyl33
      VOLK RACING GTC CENTRE CAPS

      By dyl33 · Posted

      Centre caps $250
×
×
  • Create New...