Jump to content
SAU Community

Recommended Posts

Wasn't a bad day out... track temperatures seemed a bit hot, managed to find a couple of loose hoses which are now addressed.

Was going to call you Pete but didnt have your number on hand, didnt get there till 11.30am or so...

Hardly anyone turned up in the morning. Good but cause get more track time to ourselves. Only got held up in the second session by some Commo's.

Afternoon more people, but still got some very good runs. Gotta do something about the engine temperature though.

This is my last outting with the arrowz for a while now. Gotta get a proper intercooler and a Power FC.

Guest Diabolik1

I came at around 2:30pm

Saw a R33 GTR in the garage, a grey R32 GTR and a Gunmetal grey R32 GTST (Morgs, i think it was yours but didnt see ya anywhere)

I left after about 30 mins...no 'lines were on the track, only a couple of V8s, a red Type R, red WRX and a Yellow BMW...



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...