Jump to content
SAU Community

Recommended Posts

Hey guys and girls, so I think the time has come for me to regrettably sell my beloved if I can find the right $.

I've owned this car for the past 6 years, lady owner driver smile.gif

89 R32 GTR Skyline, man, 4 months rego, 137000 on the car, motor just had a fresh rebuild done back in June, since has travelled bout 5000km.

Exterior- Black in colour, the paint is pretty average I just never got to a respray (can organize cheap respray if needed) Has a scrape near the fuel flap from a hoist, N1 front bar, n1 sideskirt extensions, rear pods. Brand new 17"x10 deep dish rims with new kuhmo tyres.

Interior- Nismo racing seat & dash. Full brand new stereo system kenwood head deck, tweeters, front n rear speakers 12" soundstream sub with amp, complete alarm system.

Suspension- Apexi height and damper adjust coilovers, adjustable camber and caster arms

Engine- completely rebuilt rb26dett, bore and hone block, chemical cleaned and serviced, full reco head with shim adjustment. Wiseco pistons and rings, tomei 260 cams, adjust cam gears, turbo smart 800hp file pump, Eboost2, Power FC, bigger radiator and cooler, gates racing timing belts, tomei valve springs, 700cc sard injectors, spit fire coil packs, Garret -5 turbos, oil cooler set up, xforce dump pipes, Nismo front pipe, xforce 3.5" cat back exhaust.

I have all receipts for the work done back in June / July.

Car makes over 500hp at all four wheels and is a pretty responsive set-up with minimal lag.

Reason for sale- Ive just lost interest to be honest!

No time wasters or joy riders please, serious buyers only! Located in Sydney, Open to swap with an evo 7 or 8. Chasing $22000ono. Pics to come ASAP!

or pm only thanks!

post-49775-0-93063600-1331418890_thumb.jpg

post-49775-0-23875400-1331418924_thumb.jpg

Edited by R31Nismoid
Link to comment
https://www.sau.com.au/forums/topic/394361-r32-gtr/
Share on other sites

  • 3 months later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...