Jump to content
SAU Community

Recommended Posts

hey,

Just inherited an R32 skyline.... The car has been sitting around for about 2 years.

It wont start..Turns over perfectly just wont pop into life! Where do i start?

I know nothing about these engines. Is there any suggestions or should I take it straight to my mechanics? which will involve in me spending $$$

Thanks!

Link to comment
https://www.sau.com.au/forums/topic/398957-r32-turns-over-but-doesnt-start/
Share on other sites

as above, if the fuel is old then it will be stale and be most of the problem. the fuel lines may also be a bit gummed up. try pulling off a fuel line and seeing if fuel is getting to the engine.

you could also try tipping a very small amount of fuel into the plenum and see if that makes a difference. if it does then you know your problem is fuel related

Nothing was wrong.. Good fuel supply, good compression, has spark....It was just because it sat around for so long that it wouldn't go. After about two hours of trying and by using some high octane fuel they got it started. They are giving it a nice service etc and should be all good :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Wrong question. There's no point in spending the rather large sum of cash and effort to add turbo, without taking it to the "sensible" limit of the motor itself. If you have to upgrade injectors, etc, then so be it. That is a tiny fraction of what it will cost you to turbo it.
    • Measure voltage at the starter solenoid terminal when the key is at start and it has clicked. If it is really low, then the suspicion falls on the ignition switch (contacts or wiring thereof) as causing a voltage drop instead of sending enough volts to throw the solenoid all the way to engage the starter itself. If it is a decent voltage, then the suspicion is on the solenoid. Might have s horted coil, or might hva dirty contacts. Rip the starter off, dismantle, clean up contacts and inspect winding. It might not be possible to see if there is a short in the winding though. I have a spare starter here that I could measure the resistance of the coil, as a guide to about what it should be, if you need a comparison. <parts hoarder>No you cannot have it.</parts hoarder>
    • lights are on just the one click.  
    • Absolutely matters because, while a temperature change will eventually reach a sensor at the end of a static line, the response time is far far far too slow to be useful. Might as well not have a temp gauge at all.
    • When I was eyeing off the 370GT (after deciding I didn't want to spend 30-40k+ to relive my early 20s in an R33) I thought it'd be a good project to add a turbo to it. Now that I have a 370GT, and I've had a couple of chances to open it up, I'm pretty stunned by how much power it makes 🫠 Honestly, the way the VVEL opens it up, it almost feels like there's a little turbo tucked away in there somewhere. It's like Nissan looked at VTEC and said "hold my beer" 😁 Has anyone thrown a turbo into their 370Z or 370GT? Is there a conservative boost level you can run without having to upgrade the fuel system, or are bigger injectors and a bigger pump a given?
×
×
  • Create New...