Jump to content
SAU Community

Recommended Posts

it's a blow off valve... sits just before the throttle body on the R33 inlet pipe. It has some pipe that comes off the outlet and goes back in down near the air filter before the turbo, but after the air flow meter. It also has a small hose that goes to the inlet plenum that opens the valve when you take your foot off the accellerator

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

BOV = Blow off Valve; Basically it either releases (atmo) or re-directs (plumb-back) the pressurised air from the inlet pipes when off throttle....

in more detail:

atmo; sends the pressurised air out of the intake pipes to the atmosphere (goes wooosh... lol)

plum-back; puts the air back through the turbo.....

i thinks that's about right.... if any one wants to elaborate you're more than welcome....

OK...I said it was a stupid question!!! So i take it that the fluttering sound is bad and that i should look into fixing it.....however my blowoff valve sound like it is working OK. Also sometimes when i apply full load to the engine, my car kinda stutters and jutters and then fangs....

sounds like pinging.... dyno's are great to test all that.... most likely something simple....

as for the BOV, you can tighten them to only go off above certain pressures/revs...I've done that with mine, which makes it flutter under about 3500 RPM then go whooosh above....

R33_BO:

It sounds like you have a BOV that vents into the atmosphere. This means that when you change gears and alike your BOV realises air outside the air intake, which means that your engine thinks you have more air in the air intake then there actully is. It does this through your AFM (Air Fuel Meter, the thing Connected to your air Filter - black box thing). Not all cars have these so they can run atmospheric BOV's but unfortunatly Skylines do...

You should look into getting a stock BOV on your car and all should be fine if the BOV is your problem...

It could be other things, dirty AFM etc...

my car makes the fluttering sound just recently... it just happened after i upgraded my air filter form the standard box.. beofre i did change the air filter to a trust (airinx), it was just making thew woooshhh sound... now with the filter on, it goes tshh tshh tshh tshh... is that a bad thing?

Guest INASNT

the flutter is ok, but if u want to be fully sick and have the dut dut dut dut sound then get a nice big turbo like a 3040 run it at around 1 bar with no bov at all and u will be fully sick. I did this with mine for about 2 weeks till i found my gtr bov's. It sounds good but farks the turbo bearings and tip of the comp wheel if u run like that for a long time.

Just like everything else u will get bored of the fully sick sound after awhile

the sound youre hearing is not caused by the pod filter, but you can hear when you fitted the pod because standard box filters the noise. The flutter noise is caused by either you've blocked your bov, or you have an aftermarket bov setup with a hard spring, causing compressor surge.

my car makes the fluttering sound just recently... it just happened after i upgraded my air filter form the standard box.. beofre i did change the air filter to a trust (airinx), it was just making thew woooshhh sound... now with the filter on, it goes tshh tshh tshh tshh... is that a bad thing?

How does it go again?

the sound goes woosh shh shh shh shh... Never stalled on me, and no idle problems or nothing.. People say on the nissan silvia forums that the flutter sound is becuase when u take ur foot off the accelarator the turbine wheel spins backwards thus cutting back through the air making the flutter sound, or something like that iforgot exactly.. im so confused now lol..

mate the wheel will not spin backwards. It may slow down do to the pressure applied but turbo rewind is a myth. Think about it ur turbine is spinning over 10,000rpm for max .5 seconds when u change gears it won't cause the wheel to slow down to a halt then start spinning backwards in that amount of time. There was a really good article on autospeed about it was ages ago tho.

that's why the skyline forums is better than the silvia forums... cos at least here we know what we are talking about!!! :P

What happens is the pressure wave reflects off the closed throttle and back towards the turbo. When it reaches the turbo, the spinning wheel chops the pressure wave (also referred to as compressed air). That is the sound you hear. It could also be you BOV opening and closing (like mine does)... unless you have removed it

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...