Jump to content
SAU Community

Recommended Posts

4 sale is my r32 gte 4 door RARE originally rb20de single cam still have orignal motor the car only has 93,000kms on it all orignal

Engine

R33 s2 rb25de

Gates racing timing belts

Gates drive belts

Drift pod filter

Nismo low engine mounts

Alloy radiator

New water pump

Driveline

R32 Gtst gear box

Exedy heavy duty clutch

Custom gear box mount

Custom tails haft

R200 locked LSD

6 bolt drive shafts

Suspension

Kyb buzz spec coil overs front and rear

R33 front sway bar

Nolafane street tuff bushes all around

Interior

Uncracked dash

Removed body deadner

Battery in boot

Pioneer head unit

Clarion speakers

Momo drift steering wheel

Tinited windows

Exterior

Sticker bombed rear window and fuel filler cap

17x7.5 in rims unknown brand

4 skyline stockies

P.m for contact info interested in swaps

  • 3 weeks later...

no it doesnt but it is ready for engineers just dont have the money to pay for the certificate. rego runs out on the 13th July and asking for around the 8g mark

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...