Jump to content
SAU Community

Recommended Posts

R33 4 door , sun roof

1993 106 thou ks on the car

Rebuilt 26/30 with standard rb30 pistons and rods

Acl race bearings balanced crank ,npc rings

Has less than 1500 kms since built ,95 %+ of kms on the dyno

Have dyno sheet for 302 kw on 14 psi

The turbo is a to4 with a 76mm front wheel 1.0 rear housing non ball bearing turbo

Power fc with hand controller ,z 32 airflow meter,walbro intank pump,catch can

60mm v band gate and screamer pipe, stainless steel 3 inch v band turbo dump

Straight through 3 to 3.5 cannon exhaust

R34 gearbox, Nizmo twin plate clutch

Hsd front shocks ,section 8 rear shocks both height and damper adjust

,hard race caster bars , hicas lock bar

Slotted front discs

R32 Gtr front seats

Volk racing 18 s on the front ,r32 stockies rear

Comes with a spare diff,spare front knuckles and uprights

,spare pair of r33 stock wheels, 25 mm spacers ,4x 17 inch wheels no tires

spare rear cut ,Spare damaged car striped out

2 defi gauges not installed cooling plate and more bits n pieces

This car is complied but has been unregoed for a long time

I was going to drift it unregoed but I have toooo many cars

It has been hit in the rear , has been pulled but has not been painted

Just in parts this is a good buy at 8500 but I am open to reasonable offers to sell fast

located 5 mis from KKs at orange grove

Pm if interested or want to come check it out

post-32345-0-79976600-1339566127_thumb.jpgpost-32345-0-67145700-1339566139_thumb.jpgpost-32345-0-94617300-1339566158_thumb.jpgpost-32345-0-75761800-1339566175_thumb.jpgpost-32345-0-77662400-1339566184_thumb.jpg

  • Like 45
Link to comment
https://www.sau.com.au/forums/topic/402451-r33-4-door-2630-300-kw-8500/
Share on other sites

  • 1 year later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...