Jump to content
SAU Community

Ls1 Rb25Det Coil Pack Loom And Coils, Fake Nismo Racing Seats, Wheels


Recommended Posts

have a coil pack loom i got made up for s2 rb25det to run ls1 coil packs with leads comes with 6 ls1 coils

i payed 100 to get loom made up and 200 for coil packs

after 200 posted.

have 2 red racing seats with nismo on there pre sure there fake

no rails no rips may need need a wash

after 200 ono

set of stock r32 gtst wheels have tryes about 40% have been powder coted black have center caps no rash ect

300 or best offer

pm for pics can be emailed or sent to phone try to get pics up today

Edited by mr turbo
Link to comment
Share on other sites

Any chance you can get me the weight of both seats and the dimensions so i can work out postage costs from you to me? (I'm in Caroline Springs VIC, but cbf driving so far for them)

also could you tell me about the bolsters on these? how stiff are they?

How do you fit in them? (if you don't mind me asking, how big are you?)

Cheers!

Ken

Link to comment
Share on other sites

  • 3 weeks later...
  • 1 year later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Latest Posts

    • I do not think that the return pipe could be the cause of your particular troubles, unless perchance it is leaking in a lot of unfiltered and unmetered air (assuming your ECU is still using AFMs). And then it could be very bad, but it shouldn't prevent you making boost. Blow then engine up from running lean? Sure. But it would make boost. You really needed to disconnect this thing from the turbo inlets and close those inlet ports off a year ago, and you should do it now.
    • Pressure Ratio = 2. ie, 1 bar of boost (assuming 1 bat absolute pressure at the compressor inlet). This is relevant because compressor maps do not have "boost" up the y-axis. They have pressure ratio.
    • Revisiting this thread again x2... 1 year later. This car has been an ongoing project between life. But, I never removed the re-circ pipe. I know, shame on me. But since then, i took it to get tuned and only making about 280hp (lame) and i'm chasing a boost issue where the car wont boost past 7-8psi. Mac valve installed. Haltech Platinum pro with the map sensor.  This is the first time i've tackled the turbo side of things, but i have that side somewhat taken apart to chase the waste gate vacuum lines. And noticed this stupid pipe again. I'm peicing together the puzzle and @GTSBoy mentioned that it was a big vaccuum chamber and said a bunch of car math stuff that I couldn't quite follow the car math (im trying). You guys think this would be the culprit? between rotting vacuum hoses?  i'm making a DIY boost leak tester this weekend. 
    • I just spent a silly amount of time reading other forums' posts and watching "whats this noise" videos on Youtube. It *appears* to be the front diff having killed a pinion bearing or similar. Its almost definitely driveline, I haven't tested to see if the car makes the noise in N though but either way I think it's gonna be pricey. This is outside my area of comfort and expertise so I'll get my BMW guys on it. The bearings are attached to the hubs so are super easy to replace (at least in comparison to press in bearings) so I'll do them also. 
×
×
  • Create New...