Jump to content
SAU Community

Recommended Posts

Ok Guys wondering if you can figure this out.. I boosted the car this morning & it hit peaked boost @ 22psi then the car backed off the power like a cooler piping came loose. Checked power FC level, ID% went to 76% n only rev it to 4700rpm. Pulled over all piping tight n vac hose all good.. I only usually peak 61-62% IDC.

Link to comment
https://www.sau.com.au/forums/topic/403721-boost-cut/
Share on other sites

Have you got the boost control kit installed or even just the map sensor? This is the only way it will cut the engine because of boost. Only other way is if your airflow voltage is to high that will give a similar effect.

Look at paulr33's power fc FAQ for the answers

Link to comment
https://www.sau.com.au/forums/topic/403721-boost-cut/#findComment-6423553
Share on other sites

Hey mate i have a HKS EVC 5 and Power FC that still uses a Z32AFM. I am thinking that the Spark plugs is not keeping up or something.. n just dumping fuel??? Only thing i can think of is turning the boost gain down a bit. What is the Max volt on the Afm so i can check it if i try again. Knock level was low @ 10.

Edited by Black_CSR
Link to comment
https://www.sau.com.au/forums/topic/403721-boost-cut/#findComment-6423572
Share on other sites

If it was spark plugs it would be a misfire, not a cut. Misfire is usually not as violent as a cut,and very identifiable from the sound. I wouldn't play around with the boost controller either, it's more likely to be something that has changed. What boost do you normally run? I assume the EVC 5 has a limit function like the Greddy Profec B?? What is that set to?

Link to comment
https://www.sau.com.au/forums/topic/403721-boost-cut/#findComment-6423578
Share on other sites

EVC is set to 21psi.. if it goes above 21.5psi it will auto turn it down to by 0.6psi and it will beep. I don't think the EVC will cause the back off in power?? I have changed the turbo intake pipe from 2.75" to 4" n the Bov was slightly open at idle so i tightened it up so it's just closed.

Edited by Black_CSR
Link to comment
https://www.sau.com.au/forums/topic/403721-boost-cut/#findComment-6423582
Share on other sites

No, it shouldn't.

t really does sound like a vacuum leak though, are you sure none of your hoses are loose or split? Is it idling ok? Even if it is, it could be a hose that's split and only leaking at higher vacuum/boost. Could also be AFM as 89CAL said, max voltage should be around 5V. But how much power are you making? I'd be surprised if you were maxing the Z32.

Link to comment
https://www.sau.com.au/forums/topic/403721-boost-cut/#findComment-6423594
Share on other sites

Yeh it ldles fine, Made 370rwhp on a roller dyno last time i checked. 350 on hub dyno with low 10 afr's. Split hose or vacuum leak?? I think i have checked all of them & they are fine. I boosted it again on the way home n turned boost gain down a bit n it peaked 20psi n ran fine. Even the BOV slightly open it was still idling fine.

Edited by Black_CSR
Link to comment
https://www.sau.com.au/forums/topic/403721-boost-cut/#findComment-6423601
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...