Jump to content
SAU Community

Recommended Posts

If you two don't knock off the whoring in threads outside of the wasteland - you are both going to see some resulting action being taken that you probably won't like.

Enough is enough guys. People have had enough of it.

2001 V-spec 2 HKS cam gears , nismo twin plate clutch ,HKS front pipe , Veilside Titanium 3.5inch exhaust , Apexi power fc ,Apexi pod filters , HKS hypermax 2 coilovers, ACPT carbon drive shaft thats about it i think stock engine turbos and fuel system, it had 260awkw @ 15psi ran a 12.2 @116mph with stock rims with 245 tyres that were way past their use by date were as hard as a rock best 60ft time i could get was 1.98sec this was done at the townsville drag strip possibly the worst prepped track in australia

Edited by gtr13

no offence and I debated with myself for a while before posting this( waits for some noob to edit quote that line), but it the way you are driving the car, I have an 11.13 @ 123 mph in my 32, and 11.8 @ 118mph in the 34 ( I have only dragged the 34 once on someone elses setup ) so a 122mph should be a mid 11, read the how to launch your GTR thread and practice

A mate ran a 12.3 @ 110 with his R34 vspec. Mods at the time were a twin plate exedy clutch, power fc, AVCR and a street tune to 1kg/cm boost. Estimated to be about 230kw atw. It was in the middle of summer and his tyres were shagged as well I believe.

A mate ran a 12.3 @ 110 with his R34 vspec. Mods at the time were a twin plate exedy clutch, power fc, AVCR and a street tune to 1kg/cm boost. Estimated to be about 230kw atw. It was in the middle of summer and his tyres were shagged as well I believe.

this sounds impossible to be honest,

people are saying they just rev dumped first which i did and smacked every gear

i started the "how to launch your gtr" thread haha its good getting everyones opinions

this sounds impossible to be honest,

people are saying they just rev dumped first which i did and smacked every gear

i started the "how to launch your gtr" thread haha its good getting everyones opinions

Well its not. He was consistent and ran 12.3's repeatadly. I know his reaction times are always good too, and he is pretty brutal with the car.

I left out that he has an 80mm titanium exhaust on it too. At the time I'm pretty sure thats it for mods

I've read that 11's are possible on stock low mounts if your willing to lean on them to the point of breakage.

Turns out that it was 111mph too:

I thought side step and dumping were the same thing

Side steo being - you move your foot to the left of the clutch resulting in stepping off instantly

Dumping - you lift your foot straight off

Besides, all you guys averaging 1.9 60' times need to get a better launch. Should be getting 1.6 60'

Besides, all you guys averaging 1.9 60' times need to get a better launch. Should be getting 1.6 60'

This guy knows stuff!!!

And I keep telling people it's all in the first few seconds of getting outta the hole that will seperate you from that average time to that great time.

I'm .1 off a 1.6 :D

if i can hear correctly.. hes ranging from 12.3 to 12.7

i can see hes trying to side step instead of dumping which was causing smoke

In other runs last year he was doing 12.3 to 12.4.

The more recent youtube footage taken this year is slower due to problems with the car not running right. An intermittent ecu fault would make his tune go rich and drop ignition to cylinders occasionally.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...