Jump to content
SAU Community

1998 R34 Gtt Sedan, Vic, 10K Ono

RSFOURDayz
 Share

Recommended Posts

RSFOURDayz Experienced

RSFOURDayz

Posted
  • Author
Posted

OK haha... Not much to say really she's pretty much bog stock, 1998 series 1 R34 Gtt Sedan in dark blue pearl, tiptronic auto, 85,000kms...

Mod list includes:

Body kit (front bar, side skirts, rear bar skirts)

Turbosmart boost controller running about 10 pound and boost guage,

3" Apexi turbo back exhaust

JVC head unit with ipod connectivity, pioneer 6" speakers in the back and 6" Jaycar Kevlar Splits up front,

K&N Hi Flow panel filter,

17" 5spoke unknown brand brans alloys with Kuhmo tyres up front and cheapies on the back (comes with 2 new spares for the back or front),

Only bad pint of the car is the bonnet needs a small repair and the bar needs painting which i was quoted 600 for all that to repaired.

I think that's about it, always serviced every 5,000 kms with Nulon oils and quality oil filter... diff oil, brake fluid, auto trans fluid, abs and steering fluid all changed the day i received it from the broker. Chasing 10k ono with roadworthy and reg till April for 13k i'll sell it with brand spanking BC coilovers, manual conversion and Black 18" Alloys with brand new tyres.

PM for more info and phone number should you want to discuss the car

post-88715-0-04569000-1346999479_thumb.jpg

post-88715-0-29494900-1346999496_thumb.jpg

post-88715-0-67730200-1346999509_thumb.jpg

Link to comment
Share on other sites
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • LjB123
      R34 GTT Wiring Harness Similarities

      By LjB123 · Posted

      Yeah not sure. I sourced another relay no problem, its definitely a relay according to Nissan parts, they used those specific relays on a bunch if cars around that time, but my two options are, find a behind dash wiring loom which is proving difficult, or get the current loom fixed up by the shop when they put my rebuilt engine back in, they are confident in their auto electrical abilities. Thing is my current loom has anti-theft stuff and GPS immobilisers wired into it so easiest option may be to just fix the current one to save ripping apart the immobiliser. 
    • winc
      Asking where to source parts

      By winc · Posted

      Took it apart to get to the bearing found out i was wrong the bearing was pressed on to the diff side and the part i removed only had the bearing side, checked the bearing all looked fine took the shaft end to a shop and they recon it was movement from back and forth that made the marks and not rumbling about, so i just changed the seal and put it all back again.
    • GTSBoy
      R34 GTT Wiring Harness Similarities

      By GTSBoy · Posted

      Oh dear. That's um. There's like. Um. a lot of bare wires there. Take the whole thing out. Something is very very shorted somewhere. IT IS NOT CAUSED BY THAT "RELAY" (assuming it is a relay).
    • Chupapy
      WTB R33 GTR 100k!

      By Chupapy · Posted

      Bump
    • LjB123
      R34 GTT Wiring Harness Similarities

      By LjB123 · Posted

      Hey all. Had a bit of a scare today with my R34 GTT when i flicked on the tail/parker lights, and  some wiring started going up in smoke under the dash. The fuse didnt blow, it just melted the casing of the fuse so must have been a crap fuse? Previous owner did alot of wiring, some of which is quite sub par and the fuse that melted was definitely newer than the other ones that were in the fuse box, but didnt seem that he touched the wires that mainly got melted. Anyway may need a small section of a new loom, is there lots of similarities between the turbo and non turbo looms especially for under the dash stuff? The wired that got friend go into a 6 pin relay under the dash. The non turbo ones are less than half the price here from a wrecker and all i would need it the section that got fried and any other wires that are affected.  Thanks in advance
×
×
  • Create New...