Jump to content
SAU Community

R33 Gtst Complete Minus Motor. Some Mods, Fuel-Exhaust-Intercooler

joe blo

By joe blo,
in Classifieds

 Share

Recommended Posts

joe blo Experienced

joe blo

Posted
Posted

hi mates got my r33 shell up for sale.

found some motors at importers for $1700 to $1900. including motor,turbo,intake manifold, injectors, flywheel and all that ready to plug into the car. car still has all wiring looms and stuff

- has a pierburg 300lph intank fuel pump and a bosch 044 external pump and surge tank hooked up in the boot.

- good intercooler piping and 600-300-76 intercooler done real good

- r33 5 speed manual gearbox though no clutch or flywheel

- no motor or turbo and stuff

- 3 inch piped throung car and full 3 inch mandrel exhaust to back of the car with cannon on back

- have dump and front pipe to cat to suit high mount turbo setup

personalised number plates included if wanted "wtf 33" slim front, usa rear

has some damage on the left rear as shown in pics. could pop out the main part and bog it or something

make good track car with a motor fitted. can be re registered easily. not on any damaged lists or anything

will sell or swap for cars, bikes , boats, go cart etc. really want a jetski

SWAP ME SOMETHING OF YOURS THAT YOU DONT WANT FOR THIS CAR OF MINE THAT I DONT WANT :)

please pm for contact so i dont have to check a million ads to see if anyones written anything

located brisbane northside

post-34298-0-07905800-1348467972_thumb.jpg

post-34298-0-43668100-1348467990_thumb.jpg

post-34298-0-00327900-1348468006_thumb.jpg

post-34298-0-79685100-1348468026_thumb.jpg

post-34298-0-85801800-1348468048_thumb.jpg

post-34298-0-79089100-1348468064_thumb.jpg

post-34298-0-74714600-1348468084_thumb.jpg

post-34298-0-11849200-1348468102_thumb.jpg

post-34298-0-40389200-1348468121_thumb.jpg

post-34298-0-67345700-1348468139_thumb.jpg

  • 2 weeks later...
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • drifter17a
      Belt flex under throttle

      By drifter17a · Posted

      Hi all, I’ve just finished fitting the timing belt on my RB25, following the standard procedure: rotate the crank twice, release the tensioner, then tighten it down. The belt feels tight, and you can see that clearly in the picture below I’ve heard some people say it’s actually better for the belt to be slightly loose rather than too tight, as excessive tension can lead to snapping. So that’s in the back of my mind. What I’m seeing is this:  • At idle, the belt looks fine.  • But when cranking and especially when revving (around 3–4,000 RPM), there’s a momentary flap/flex or flicker in the belt, which I’ve tried to capture in the video. So my question is — based on what you see, is this slight belt movement something you’d consider normal, or am I just being OCD? Could this amount of movement cause sync issues? Or is it just a harmless bit of flex under load?   from what I know belt flap and flex is expected when crank spins up and pull cam with it Would appreciate any thoughts or similar experiences.     IMG_7656.mov IMG_7657.mov
    • EddieR34GT-X
      R34 Gtt Wheel Offset Advice

      By EddieR34GT-X · Posted

      I've replaced the front brakes of my NA to 324 brembos and 350z calipers: i'm going for 225/40-18 up front and 245/35-18 in the back. I have Rays 7.5*19 ET35(225/35) in the front with 5mm spacers otherwise the calipers "lock up/ won't rotate". When i use the calculator i come up with 8*18 ET30 for 225/40...... but not sure i get problems with the calipers. Anyone riding around with 18 inch. that can confirm "that it'll fit"? In the back it's 7.5*9 ET30 (245/30) with the 5mm spacers, but there is no problem with the standard small brakes, so i want to take 8.5*18 ET25 (245/35).
    • Shizu
      Returning after a long time!

      By Shizu · Posted

      Lol.. but then.. always come back to a JDM..
    • luke gtr
      What's this Foreign Object?

      By luke gtr · Posted

      Glad to hear. If possible, get your tuner to check air's to make sure everything is still where it should be.
    • Kinkstaah
      Hello fellow enthusiasts

      By Kinkstaah · Posted

      The problem with FB/Insta/Reddit etc comments relating to cars is simple. You get to ask a question once, and get one round of replies. For things that can actually be answered in a few lines of text, once, it's fine. After 6 hours, your original question is lost to the void. There are no follow ups, additional questions, anything. No project car is ever such a simple list of questions to ask. You need discussion.
×
×
  • Create New...