Jump to content
SAU Community

Recommended Posts

Hi mate, had this before - you will need to take the headlight to a place that can;

1. place it in an oven to soften the glue that binds the headlight

2. pry open the headlight and re-clip the blinker cap

3. re-seal the headlight with new glue

if you're unable to dis-mount the headlight yourself and are in sydney, you can take the car to Top Secret in Blacktown - who can remove the headlight without damaging any of the clips and then organise for the headlight to be repaired at Plastifusion - which is just around the corner - whilst your car is kept safe at the Top Secret workshop;

if you can remove the headlight yourself you can take it directly to Plastifusion for repair

Top Secret Service Center;

Jack (director) or Pete (head mechanic)

Unit 2, 1-3 Carnegie Place, Blacktown

Phone: (02) 9621 5700

[email protected]

http://www.topsecret....au/index-1.php

Plastifusion

Address: Unit 2 170 Sunnyholt Rd, Blacktown, NSW, 2148

Phone number: 0298318018

Read more: http://www.startlocal.com.au/auto/wreckers/nsw_sydney/Plastifusion_2487986.html#ixzz2IEHAyCe2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...