Jump to content
SAU Community

Wtb Turbo


Recommended Posts

There has been heaps of these threads lately which should help you out, but contact HyperGear for a simple replacement.

Dont bother changing the turbo unless you do all the supporting mods to go with it, a turbo with a stock setup will do you no favours

Link to comment
Share on other sites

Sorry mate just a bit new to the site, started the account ages ago but only just started to use it..

In my r34 I've got

HKS FMIC

HKS 3" stainless turbo back exhaust

VDO 650cc injectors

Walbro Pump 400 LPH

Eboost street boost controller

And starting to organize a nismo type 4 board chip. That stuff is ok to start looking at another turbo isn't it? Also I want to get a wastegate but unsure on what to get? So any advice would be great!

Cheers!

Link to comment
Share on other sites

Yes you have some basics, i assume you mean the NIStune board which is good value for money..... If you want an easy bolt on kit look here - http://www.skylinesaustralia.com/forums/topic/261613-hypergear-hiflow-service-continued/

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share



  • Similar Content

  • Latest Posts

    • Does it have a vacuum brake booster? If it does, and the booster isn't connected you will get TPS and all sorts of other codes, and it will struggle to idle Have you driven the car, checked the brakes?
    • Yep battery was off the whole time. I did have to reset about 1000 "adaptations" in the various ecus but no love.  I might pull the throttle body out and give it a clean but I'm not convinced. I don't get why it runs fine at higher revs. The cold start today was beautiful! 
    • Did you disconnect the battery for a while? It might need to relearn how to BMW, maybe?????
    • My happiness was short lived.  The car has a violently rough idle. If I get the revs up it runs really nicely albeit with some very small misses occasionally. I have checked and double checked all my connections and vacuum lines. I've even replaced some unrelated vacuum lines to to and find the problem.  The codes are all over the place. Throttle position, throttle vacuum, o2 sensor 1, o2 sensor 2, occasional misfire code. Makes me think a wire has been broken or something isn't clipped in properly but there's so little around where I was working to miss plugging in or to break. Super weird.  It's only at warm idle. Cold start is beautiful until the revs drop below 850 - 900 rpm then all hell breaks loose.
×
×
  • Create New...