Jump to content
SAU Community

Recommended Posts

hi guys iv searched the forums here and around the net and couldn't find anything to help me so hoping someone here can

I have a 1993 r33 gts25t. its stock under the hood besides a fmic, nismo fpr (coz stock one died n couldn't get another one), hks bov and a pod filter

I don't drive it to often so started it in the shed n let it idle to put some charge in the battery. it was running fine then the idle started to fluctuate slightly then it stalled I tried to start it n it turns over but wont fire up.

I have limited mechanical knowledge so I checked all the basic things its got spark its getting fuel all the fuses and relays are fine.

so following info I found on the net of things that could be the problem iv replaced cas, afm and ignitor and still no luck.

any info or suggestions would be greatly appreciated Thanks Heaps

Link to comment
https://www.sau.com.au/forums/topic/426483-r33-wont-start-all-help-appreciated/
Share on other sites

fuel I pulled off the return line n injectors clicked when I rotate the cas and the plugs where wet when I pulled them out and spark I removed the coil packs and plugs one at a time n placed the plug in the coil pack and earthed it to a battery with a jumper cable and had a mate turn the key.

I just read on here that one guy found even though the plugs fired out of the engine they where still to weak to start the car so ill try replacing the plugs tomorrow.

I had a problem like this before an it was the power supply to the coils, It red fine with a volt meter but had no current, to check this get a headlight globe pref. 100w , find the power wire on the coils-remove all the plugs off the coils to confirm the power supply wire see if it glows the bulb bright like a headlight-if not you have found your problem area. Is it the model with the ignitor at rear of engine or do the coils have inbuilt ignitor.I think 93 has the ignitor.

yes it has the ignitor at the rear of the motor atop the coil pack cover

I checked the power supply to the coil packs like u said an it is fine the bulb was blinding lol

this first happened a few months ago but haven't had the time to work on it till now I thought I was getting fuel then but after closer inspection to day it looks like there's fuel in the feed and return line but its not making it to the cylinder coz the plugs are bone dry now after cranking for 5 seconds

discovered iv got no power to the injectors checked all the wires and earths and is all good so and everything else appears fine fuel pressure, spark, injectors them selves. So im thinking its a problem with the ecu.

is this a likely possibility???

if the plugs are wet then the injectors sounds like theyre working.

did u only jist install the fpr? sounds like the pressure is too high and u have fouled the spark plugs.

get some new spark plugs and set the fuel pressure to 43.5psi when the pump primes. then see if it starts

hey plugs where wet when It first happened but are bone dry now

I put new plugs in and the fuel pressure is set at 43.5psi

I spoke to the mechanic at the local Nissan dealership said it sounds like the ecu but when I asked if I could ring it in there he said they not interested in working on it :-(

so I got another ecu do I just unplug the old one n plug in the new one or is there other steps to replacing it ???

If I here ecu one more time I'm gonna burst into laughter, I have seen r33 ecu,s cooking when my mate reversed the polarity to his battery for 2 minutes. There was smoke coming out the engine bay then he swapped it over and it fired right up please accept out information, it is your battery or ignitor unless a magpie got stuck in your alternator and the battery didnt charge properly.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...